I have an Alto Cordless by Logitec. This was runing well, but since a time ago, this delay key strokes and after that, repeat many times the same letter. When i write from the notebook keyboard, all runs well. I clean the keyboard, change batteries, and, all is the same. I think about some from driver, but this keyboard dont use any at all. Any ideas? Thanks

why not post symptoms, and not guess at parts that may or may-not
exist.?
the fuel cut off switch is the ignition key, and works all the time.
The Maruti Alto is the Indian-built version of the fifth generation Alto
796 cc (0.8 L) F8D I3 (petrol)
998 cc (1.0 L) K10B I3 (petrol)
1,061 cc (1.1 L) F10D I4 (petrol)

or
Seventh generation (HA25) Alto from Japan.
796 cc (0.8 L) I3 (petrol)

what engine, the fuel systems vary by engine, and country sold to.
neither sated.

Go under CONTROL PANEL then KEYBOARD and adjust the sensitivity. It is probably set too high, thus repeating keystrokes.

Try running connect MANY times. it may sound goofy, but come to find out I had a new set of cordless phones which used similar freq's. so try to do connect several times.

Hi,

Check if power adapter is working. try to use with different USB port.

Regards;
Hasan

ya got a few choices here
1. get a better computer
2. upgrade your computer
3. use a different computer
4. stop using yahoo mail
5. start using other free mail sites
6. stop watchin the clock
7. go to bed and stop stressing that you have a bad computer/internet connection

You can change the repeat delay times on your keyboard.
Click on the Control Panel then Keyboard icon. In the Speed tab you can change the Repeat delay and the Repeat rate settings to suit your requirements..

MAY BE BECAUSE THE KEYS DON'T COME IN CONTACT WITH THE PLASTIC LAYER IN KEYBOARD OR MAY BE COMPUTER DOESN'T GET CORRECT INPUT SIGNALS

I see no reason that the mouse should not work. They have the Xop driver and the install software. Download both and also read henote that they are talking about in. red. I didn not download it myself. If this doesn't work you can get a common PS 2 mouse for a small amount  most anywhere including Walmart.

http://www.logitech.com/index.cfm/428/165&cl=us,en?softwareid=4338&osid=1

To adjust the key repeat rate

1. Open Keyboard in Control Panel.
2. On the Speed tab, make changes as follows:
   • To adjust the amount of time that elapses before characters repeat when you hold down a key, drag the Repeat delay slider.
   • To adjust how quickly characters repeat when you hold down a key, drag the Repeat rate slider.

Note

• To open Keyboard, click Start, click Control Panel, click Printers and Other Hardware, and then click Keyboard.

Good luck and please rate me

You probably already done this but try pressing the receiver button and while it is flashing turn the board over and press the small reset/connect button on the bottom of the board and also the reset/connect button on the bottom of the mouse. It should work okay after that. here is hoping that helps. Bud