- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Did you check the adjustment setting on the brightness and contrast?
These two setting can be moved and stop the CRT from displaying,
Please move these two setting to MAX and see is there any image on the display.
connect another cable as follows 1-red 2-green 3-blue 4-gnd 5-gnd 6-red gnd 7-green gnd 8-blue gnd 9-+5v from display card 10-stand by 11-synchronus ground 12-sda 13-hsync 14-vsync 15-scl
the numbers of pin are given under pin
your power supply is probably bad. open the case with it unpugged and look for leaking or crowned capacitors. most electronic repair shops can replace them for you
my samtron 56v problem stand by when i power off yet i power on it is off position whats problem with me.switch is many time pressing then is on position.what is parts of my monitr suplly fault.wich part is spoil
The problem im facing is, im using a Samsung samtrong 56V monitor, there is horizontal line appearing in the both ends of the monitor screen which gives a mirroring effect. ( for ex: if ya move the cursor on that it will show multiples of cursors displayed in that line only.)
Please suggest me a method to solve this issue. are there any patch avail for this if so please send a link to download.
If this behavior is relatively consistent, I would suspect the "mains capacitor", an electrolytic cap on the output of the AC bridge. If vibration affects behavior you may have cold solder joint(s) in the SMPS circuit. Knowing what current the monitor is drawing at turn on would be helpful.
×