Question about HP LaserJet 3055 All-In-One Printer

8 Answers

HP LASERJET 3055 Manual IP Address not saving

We have three HP LaserJet 3055 all in one printer which we thought as good all in one printer. However, recently one of system failed to accept Network Printing and when I have checked I found that the Manual IP address given to the printer lost. The printer control panel shows IP address as 000.000.000.000
I tried several time to set the IP address 192.168.1.11 and even printer menu shows "setting saved" but within next minute if I check the IP, it shows the same 000.000.000.000 IP address.
(Menu > Network Configuration > TCP/IP > IP = 192.168.1.11 > Yes > Settings Saved)

The Report for Network Configuration shows Following two important symptoms:
A) Status = Initializing
and
B) IP address = Configuring

Show to HP engineer, they told that main board is required to be replaced and the cost they told was almost 40% of the new HP 3055.

Now the same problem observed with the second HP 3055 and again same symptoms. It does not save IP address even the control panel confirms "Settings Saved"

Any idea, is it related to any firm ware problem or actually a printer's main board problem ?


Thanks in advance.

Posted by on

  • 2 more comments 
  • olhodolago Jul 16, 2008

    I have that same printer and it wont set auto IP assign. when I print a network config report it shows "IP adress: configuring" and "auto IP disabled" no matter how many times i set up to auto-assign

    any sugestions?
    Thanx



  • ahart168 Jul 17, 2008

    I have exactly the same problem as described here. For over a year, the
    printer worked flawlessly over the network. Now it has this behavior as
    described above.

    I do not think it is the (only the) network card: From the time the printer is first turned on, for approximately 15-25 seconds, the lights on my network switch indicate a fully normal connection. Then, at some point during the start-up routine, it appears the network connection is configured by the printer, and the connection drops to half-duplex. A printout of a 'network report' confirms this is the case, and, no matter what is done, the printer will not accept (store) IP settings. This makes me think the problem lies with whatever onboard memory the printer makes use of to store configuration settings, especially since they don't seem to be saving correctly.

    I'll just note that doing a "Restore Default Settings", or "Reset TCP-IP" does not seem to re-initialize the default factory settings for the network.



  • Anonymous Oct 09, 2008

    My ******* HP 3055 also does the same, and tried everything, but has no solution: does anybody know what to do?

  • minto cv Mar 30, 2009

    ip address not saving

×

8 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Hi,
Switch off the printer and press * & enter key together &switch on wait till you see " permanent storage int"
then release button your printer comes back to original defaults
then re-configure printer as you require

Murali,
PALLAVI INFOTECH
BANGALORE

Posted on Jun 01, 2009

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Hi,
Try this trick,First switch off your printer hold the button symbols & Enter for few second then turn on the printer do not release the button till the printer switch on totally,then enter the ip address & wait for ten minute.Now your ip will be saved.

Prabhakar.

Posted on Feb 12, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Hi guys,

Thanks a lot this solution 3 worked for me. I was considering to buy a new printer because of this. Thank you so much. My printer is so critical for my work.

Pat

Posted on Jul 31, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Try Pressing the "*" Button and the Number "5" at the same time while the printer starts up. This will initialize the NV RAM of the printer, which stores the printer settings.

This could remove any defragmented data from the NON Volatile RAM of the printer and hence resolve the IP drop issue.

Posted on Aug 27, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

How to assign network ip address in hp laserjet 3055 printer

Posted on Dec 15, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • HP Master
  • 1,362 Answers

Try doing a cold reset first, then check that DHCP is manual not Auto. then try to input IP address again. If the Network card is seperate then you may only have to replace the Nic

Posted on Jul 16, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I done cold reset & permanent storage ,Number "5" ,DHCP is manual but problem is not solve . pls, provide me ans. i am weating for reply. friends ( ratish_asd@yahoo.com)

Posted on Aug 01, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Thx Yaron

Posted on Aug 29, 2009

3 Suggested Answers

  • 61 Answers

SOURCE: HP LaserJet 3055 unable to save IP setting

i can solved this problem please give me one chance

Posted on Jul 24, 2008

  • 1 Answer

SOURCE: HP LASERJET 3055 Manual IP Address not saving

Try flashing the firmware: one of the fixes is this - (Improved IP address management of DHCP to Manual changes).  See link below. Firmware


Gerben People tend to evaluate events in light of their paradigm rather than evaluate their paradigm in light of events.

Posted on Oct 07, 2008

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW TO CONFIGURE LASERJET 3055


USB: Run the cd, when its asked for connecting connect the usb cable, do rest..Network. Menu>network setup>TCP/IP>enter IP address>save it.connect network patch cable, take configuration page through printer menu settings, verify the IP address save or not> go to system 1. Run the CD select network as network printer> system will detect the printer go for rest of the process..
2. Through system> start> settings>printers& faxes>add printer wizard > select as local printer> select create new port in dialog box> select TCP/IP> type configured IPadress> do rest of the run process..

Jul 11, 2012 | HP LaserJet 3055 All-In-One Printer

1 Answer

The HP 3055 network printer, connected to 3 dell inspiron laptops doesn't print...it says it's offline, even though the screen on the printer says "ready." I tried adding a printer profile and...


Hi there,
Check the IP of the printer, it should be manually assigned, if you are not confirmed,
  1. Press menu/enter .
  2. Use the or the > button to select Reports , and then press menu/enter .
  3. Use the or the > button to select Config report , and then pressmenu/enter .
  4. The printer exits the menu settings and prints the report.

Try re installing the printer software from the cd, or download the full version from the links below for your area
HP LaserJet 3050/3052/3055/3390/3392 Asia Pacific Full Software Solution

HP LaserJet 3050/3052/3055/3390/3392 Eastern Europe Full Software Solution
HP LaserJet 3050/3052/3055/3390/3392 North America/Western Europe Full Software Solution
(The full software solution provides print, fax and scan functionality. This software solution is the same solution as the Version 4.0 in-box CD that came with your HP LaserJet 3050/3052/3055/3390/3392.)
You can download Printer manual from the link below
Printer Manual
If you require more assistance in this regard feel free to reply to this post
Best regards-BA

Jan 20, 2011 | HP LaserJet 3055 All-In-One Printer

1 Answer

Hello, I have a LaserJet 3055 that cannot retain a static IP address. I am able to change the IP to what I want, but still ,it does not connect. Anytime I shut the printer off it losses its IP, the...


Hey!

Make sure that the printer's DHCP is not on because the only time it looses the ip address is when its not on static and on DHCP!

Hope it helps!

Jan 10, 2011 | HP LaserJet 3055 All-In-One Printer

1 Answer

Ip not save in hp lj 3055 aio


Please describe the problem in detail. IP is never saved in any printer.

Dec 22, 2010 | HP LaserJet 3055 All-In-One Printer

1 Answer

Hp 3055 all in one ip address is not saving


http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00495173/c00495173.pdf.....Check this link, this is the user manual of HO3055 all in one printer..

Nov 10, 2010 | HP LaserJet 3055 All-In-One Printer

1 Answer

HP LASERJET 3055 Manual IP Address not saving


Try flashing the firmware: one of the fixes is this - (Improved IP address management of DHCP to Manual changes).  See link below. Firmware


Gerben People tend to evaluate events in light of their paradigm rather than evaluate their paradigm in light of events.

Sep 27, 2008 | HP Officejet Pro L7780 All-In-One InkJet...

3 Answers

HP LaserJet 3055 unable to save IP setting


i can solved this problem please give me one chance

Jul 05, 2008 | HP LaserJet 3055 All-In-One Printer

4 Answers

How to install Hp laserjet 3055


If the connection is ethernet. Print configuration from Printer.
Manually install printer.
Select computer is on local port
Local port to select is TCP/IP
then type in the network address to the printer.
Driver will still be inside computer.

Mar 03, 2008 | HP LaserJet 3055 All-In-One Printer

5 Answers

HP laserJet 3055 network connection


HOW TO CONNECT HP 3055 TO ROUTER/WIRELESS NETWORK. WINDOWS XP/WINDOWS VISTA.

I have just finished successfully connecting my HP 3055 to my router and using it over wireless on 2 computers, one with windows XP SP2 and one with VISTA.

INSTRUCTIONS FOR CONNECTING HP 3055 ON XP:

FIRST CONNECT THE PRINTER TO THE ROUTER WITH A ETHERNET CABLE. FIND OUT THE IP ADDRESS OF YOUR PRINTER. By me it was 192.168.0.66

Go to CONTROL PANEL and open "PRINTERS AND FAXES". on the top left choose "ADD A PRINTER" click "NEXT".

In the "LOCAL OR NETWORK PRINTER" window, choose "LOCAL PRINTER ATTACHED TO THIS COMPUTER" and uncheck "AUTOMATICALLY DETECT"... click "NEXT".

In the "SELECT A PRINTER PORT" window click the radio button "CREATE A NEW PORT", click the down arrow and choose "STANDARD TCP/IP PORT".

In the window that pops up click "NEXT"

In the ADD PORT window, where it says "PRINTER NAME OR IP ADDRESS, type in your printers IP address, by me it was 192.168.0.66. The bottom line will fill in automatically. Click "NEXT".

In the "INSTALL PRINTER SOFTWARE" window, if you have the disk just choose "HAVE DISK" and install from there. If not, in the left column choose "HP" and in the right column choose "HP LASERJET 3050" (by me it showed up in the list, you can download the driver from here http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=1140780&prodTypeId=18972&prodSeriesId=1161389&swLang=8&taskId=135&swEnvOID=228

click "NEXT"

In the "NAME YOUR PRINTER" window, choose a name and also choose if you want to set it as the default printer (recommended) Click "NEXT"

In the next window choose whether or not you want to share the printer, and if you do assign a printer name. Click NEXT. The next window is optional if you want to make a name, you can just click NEXT and your done! Print a test page to make sure that all is fine.

Feb 11, 2008 | HP LaserJet 3055 All-In-One Printer

1 Answer

Hp 3055 all in one


ok DO check my link to setup the network
http://www.fixya.com/support/t391229-hp_laserjet_3055_network_connection


thank you

Dec 14, 2007 | HP LaserJet 3055 All-In-One Printer

Not finding what you are looking for?
HP LaserJet 3055 All-In-One Printer Logo

7,933 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Office Equipment & Supplies Experts

Seeker5211
Seeker5211

Level 3 Expert

1089 Answers

kakima

Level 3 Expert

100140 Answers

mukhtar21 shaikh
mukhtar21 shaikh

Level 3 Expert

2017 Answers

Are you a HP Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...