Question about Mitsubishi WD-52525 52" Rear Projection HDTV

1 Answer

Mitsubishi wd-52525 dm board capacitor replacement

Hi Techman, I've done a little research and you appear to be the expert on this. I'm basically at the point where I have the chassis completely removed from the the set and I'm wondering how to get this dm board removed from it and which capacitors to look at. Is there an article anywhere online that will tell me exactly what to do? I've got the service manual and everything and it tells you how to remove the chassis, but not how to mess with the board. Hope you can help me man :) My e-mail is

Posted by on

  • husker_shoe Jul 19, 2008

    Thanks alot foe the help. I know it's not an easy job as I just started tearing into it and the next thing I knew, the screen came off. Really not too bad though:)



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 927 Answers

Good day, husker_shoe;
Good question, but I'm not THE FAMOUS "TECHMAN" but I will try to help anyway. The DM board is normanlly on the left side TV looking from the back. It has a shield around it, remove. The caps are big and black, they look the replacements(only ones on board). Here's what says about this issue:

If the LED keeps blinking with connector FC removed suspect a problem on the DM PCB (part # 934C116002). (LED does not stop blinking after plug in) On the DM
Good Luck, big IRISH. ps hope this helpful!
PCB (part # 934C116002) check C81A2, C81A3, C81B3 and C81B4 (1000 UFD, 16V, 105C), if any are bad, replace all of them with part # 181P734030 (680 uFD, 16V, 105C). (LED does not stop blinking after plug in) On the FMT PCB (part # 930B924002) check C8F19, C8F21, C8F22, and C8F27 (16V 1000 UFD 105C), if any are bad, replace all of them with part # 181P734030 (680 uFD, 16V, 105C).
It is not an easy job, it will take some time but since you have it apart there is another problem that will accure so might as well do this too:
Tile or block pattern with no video or OSD. Check D8F00 and D8F01 part # 264P828010, also check C8F26 and C8F29 part # 141P148000 (1 uFD, 25 V) on the FMT PCB (part # 930B924002).
All the parts have location numbers like C8F29 that will tell you what and where these parts are.
Good luck, big IRISH. PS; I hope this helpful.

Posted on Jul 19, 2008

  • MICHAEL MULLINS Jul 19, 2008

    Good Day, husker_shoe;

    Good job so far just take your time and mark any cables so you will know where plug back into.

    Again good luck, big IRISH.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How can i make my essay more easy ?

essay topic-you've done plenty of research and know everything that there is to know about your topic-and yet, you can't seem to put pen to paper. You have plenty of great thoughts and ideas about where you want your essay to go, but what you really need is a plan of action. This is where an outline comes in.

Mar 22, 2014 | Computers & Internet

1 Answer


Make sure your 12V grounds to engine and chassis are good.

Apr 11, 2017 | Mazda RX8 Cars & Trucks

2 Answers

How to higher lvl on this web site faster? i asked question earlier and it says i have to be lvl.2

As an Expert on FixYa you are earning points as you are answering questions.
Each question on the site worth points: newer questions worth 3 points and older 1 point.
Experts with 0-99 points are level 1 experts, which means that they can view newer questions.
Experts with 100-999 points are level 2 and can view newer question and also questions that level 1 experts were not able to answer and skipped.
Level 3 experts with 1000 and up points can view all types of questions.

The more questions you answer the more chances you have to appear on our Leaderboard

The Leaderboard presents the top experts per week which means that not only top experts can appear on it but also new and enthusiastic experts who answered many questions in a specific week.

*Please note that our content team is reviewing the questions and answers on the site to make sure that the quality of the answers is not being compromised by quantity.

Sep 11, 2012 | FixYa Computers & Internet

1 Answer

I have a 1994 k2500 suburban with very little tow power.I've done a complete tune up, replaced the fuel filter,Had the trans checked, replaced egr,cat and muffler,good fuel pressure,compression 14

Have you tried to manually downshift the trans going up hills? Sounds like the trans is not being told to downshift .

There is a test machine, (Want to say Odessey) that is attached to your truck and the truck is driven while hooked up. This machine can be asked questions by the mechanic. It has more electronics in it than the onboard computer. You would have the trailer attached to reveal realtime operating conditions.

It basically can do what a Dynamometer can do, while pulling a load. Even if it cost substantially to do this test, you would save by not buying parts you do not need.

Find a Dealer who knows about this type of machine and has one to use on your truck.

Sep 03, 2012 | 1994 Chevrolet Suburban

1 Answer

Where can I purchase a tick twister?

I've done a little research for you and I've managed to find a great web site which sells almost everything regarding pets and pet's ticks and fleas, just follow the link

Aug 14, 2012 | Pets - Others

1 Answer

1987 Toyota Celica GTS alternator/charging problems

the ground wire from the body to the engine is bad

May 26, 2012 | Cars & Trucks

1 Answer

Loss of suction. it still has some but not as powerful to the point that the little attachment brush does not spin. I have cleaned the brushes.

Hi there,

I'm sorry to hear you're having difficulties with your DC17. If it doesn't seem to be picking up as well as usual, it's possible that there's a blockage in the system - I'd also recommend giving the filter a wash.

The easiest way to check for and remove any blockages is to follow the steps shown in our online support guide:

The correct way to wash the filter is shown in the video linked below. Under normal use, this should be done at least once every 3-6 months. Use cold water without detergent, and allow up to 24 hours for the filter to dry completely before replacing it.

By clearing any obstructions and washing the filter, you should be able to resolve your issue without further assistance. However, if you've tried this and are still concerned, it's probably best if you get in touch with us directly. You can call us free on 1866MYDYSON. One of our experts will be happy to run through some troubleshooting over the phone with you, and to recommend the best course of action.

Kind regards,

Dyson Online Customer Support

Jun 25, 2011 | Dyson DC17 Animal Bagless Upright Cyclonic...

1 Answer

Where/how can I get a owners manual for the Mitsubishi 36" TV (Model# CS-36509)?

what is it or what info are you looking for this set is an older mitsubishi older chassis -Zm chassis and is the same set as the mitsubishi modelCS_4053 there are no boards available for theses sets any longer, Sorry Man

May 18, 2010 | Televison & Video

1 Answer

Hi paul here can you help? i have a peugeot expert hdi van 2002. i had a little bang from it and now it gives a lot of black smoke and has no power when i try to go faster, do you think this may be the...

Hi ,
you need to check the air pipes from the turbo as it sounds like you`ve blown a pipe they fail due to oil inside,quite a common problem and not expesive to fix

Jun 30, 2009 | 2006 Peugeot 604

1 Answer

Sanyo DS32224 TV blurry

Do you have the original remote for that TV set? If you do not, you will need to get one or borrow an original Sanyo remote so you can get into the set's menu and go to puicture set up and try adjusting the constrast up a little bit.

Mar 20, 2008 | Televison & Video

Not finding what you are looking for?
Mitsubishi WD-52525 52" Rear Projection HDTV Logo

2,981 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1213 Answers

The Knight
The Knight

Level 3 Expert

74999 Answers

Jaime Hernandez

Level 3 Expert

2326 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides