How many kilogramos is the capacity of the mytag ensignia

Yes, they don't make them like they used to and it is definitely worth fixing. Black dust is almost certainly the belt. Pull the machine out and tip it backwards against the wall. Have someone hold it steady and look underneath with a flashlight.

Worn bearings make a noise.

Parts 30 on drawing 1 is your belt. $39 Canadian. It is a long belt! Make sure the pulleys are okay and the motor and gearbox turn freely.

The drain hose has to be at least 30 inches above the floor or gravity will drain the machine. Also: If the water hose is jammed into the drain a siphoning affect will occur in some instances.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

I have the same problem. I'll post if I find a solution.

Try Googling " user manual for Maytag Ensignia MDE4658AYW ". You may have to go to the Maytag web site and ask for manual. Sometimes I've had to ask for repair manual instead of user manual. Good luck.

sounds like your balancing ring or your springs gave out underneath to balance load

You need to remove the cover and check the voltage to the cold water inlet valve. Do this with a volt meter while it is set to fill with cold water. It is most likely an AC voltage that is around 24 volts. If you have voltage then the valve is most likely bad.

WHERE DO YOU SEE LEAK AT ,,, FROM TUB SEAL???? OR PUMP ////CAN ALSO BE HOSE TUB TO PUMP????????

Check the water level control, it could be stuck or faulty.

same problem - stopped spinning, white dust - belt and motor r fine. Can anyone diagnose?

replace the pump pump is leaking