I need a 24 volt dc power adaptor for microsoft racing wheel (xbox360) can you help, thank you. [email protected] R souter

Most new power supplies can only be turned on via motherboard signal. That is why you have to plug in the 20/24 pin connector from PS to mo bo. When operating yellow wire is 12 volts and red is 5 volts DC. And black is ground.

if your volt is 220v. so you can use fuse on AC line 600mA to under 1Amp.
DC line fuse is under 12Amp. clean any power cable port & use perfect gas.

The power connector needs to be soutered back onto the board.

Here is a tutorial.
http://www.laptoprepair101.com/laptop/2007/12/06/dc-power-jack-repair-guide/

I think you should check the real power supply ... 120 V in and what comes out ... volts (ac - dc) and amps or what fraction of an amp.

Please compare the old with the new power supply. The new power supply should be the same volts - same kind (AC or DC) and at least the same amp rating. You can use higher amp rating but not lower - lower will burn up - literally)

Volt meter ... always set it above the suspected voltage. Batteries are always DC. Houses, buildings, etc always AC. Power supplies - could be mixed - ac in and dc out.

So if you were measuring in your home, you set the meter to 130 or higher on the AC scale. If you were doing your auto, 24 volts DC (or so).

House current, probe color doesnt make any difference. Should read about 120 Volts between the narrower (or right side/ground down orientation) or the two slots and the wider of the two shots (wide should be the neutral side - ground on the bottom). You can prove the hot side by measuring to the ground. White wire to ground = no reading. Black wire to ground = 120 volts. (The black and white are INSIDE the electric outlet. You can use either probe to do the measurement.

I hope this helps you.

If you have more question, please let me know.

Thanks for using fixya.com

a

1/4" 24 Volt dc (center pin is positive) at 0.75 A or more.
The device will only use what amperage it requires.

Power supply is 1/4" 24 volt dc (center pin positive) at 0.75 A.
GL on the allthread post.

Try:
1. Check your setting once more.
2. Reinstall sterring wheel drivers.
3. Reinstall game.

I hope this helps,
Yannick.

Hope this helps.
Part No. 96749 (Maybe Ebay?)
Input: 230V~ 50Hz
0.15A
Output: 12V 1.3A

This one may be hard to find at a retail store so I am sending a link I found. they have available slip on tips to match your equipment.

make sure you know if you need an 120v AC to 24vdc or 120v AC to 24v DC there is a difference 24vdc (volts DC) 24vac (volts AC) you will be looking for a 1500ma typical rating for this type or transformer

I have not purchaced from this place before nor do I endorse it just trying to help http://www.powerstream.com/24-volt-dir.htm

Hope this solves your problem

click on hyperlink:
buy replacement ac power charger adapter DURBRAND MODEL # APX001A