Question about Karcher 2500 PSI Pressure Washer

1 Answer

Karcher 2500 no pressure problem

Engine runs fine pressure came on for about two seconds and then quit. Tried just letting engine run a while to build up pressure, but no luck.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 33 Answers

Sounds like you have an inlet blockage to the pump or not enough volume to feed the pump. make sure hose is turned full on when washing and see what happens. if not you may have to remove adapter wher hose screws in and check for a blockage.

Posted on Apr 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a karcher high pressure washer model hd 2500 hk. What would make my unit stop running after about 45 seconds ,running at full throttle and at high pressure


Hi,

There could be two possible causes for your problem, one is oil level in the engine could be low, or the engine is tilted or not positioned on a level ground, and the second one is water in the carburetor. Check the oil level and replace the oil if necessary, drain the fuel from the fuel tank and the carburetor and clean the carburetor ports and jets, check the fuel for contamination, check and replace or clean the spark plug if necessary, check if the air filter is blocked, dirty, carbonated, or saturated with oil, and replace if necessary.

Jul 30, 2014 | Karcher 2500 PSI Pressure Washer

1 Answer

Engine will not remain running


sounds like the carb needs to be rebuilt and adjusted..good luck

Apr 03, 2010 | Karcher 2500 PSI Pressure Washer

1 Answer

Presure relief value not working when let off trigger on wand


sounds exactly like the problem and the soluition you are looking for.

Mar 12, 2010 | Karcher 2500 PSI Pressure Washer

1 Answer

Troy bilt pressure washer will not build or reach high pressure


check the non-return valves in the pump block. if these are damaged or dirty you pressure will be greatly reduced. they are located behind the 3 lage brass hexagonal caps.

I hope this helps

Sep 04, 2009 | Karcher 2500 PSI Pressure Washer

1 Answer

Pull cord is locked. Was running fine and just


any oil in the engine? pull cords are easy to replace but sounds like you run out of oil and the engine locked up!

Jun 21, 2009 | Karcher 2500 PSI Pressure Washer

1 Answer

Won't run with float valve on


make sure when you put bowl back on carb the float isn't being jammed all the way up. if there is an o ring sealing the carb bowl shoud be no problem. don't know what type engine your talking about.

Jul 10, 2008 | Karcher 2500 PSI Pressure Washer

Not finding what you are looking for?
Karcher 2500 PSI Pressure Washer Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top Karcher Pressure Washers Experts

John Trevino

Level 3 Expert

1378 Answers

andy just round the...

Level 1 Expert

47 Answers

EugenesDIYDen
EugenesDIYDen

Level 3 Expert

479 Answers

Are you a Karcher Pressure Washer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...