Mine does not work any more. I tried a Toshiba replacement but that does not work either. Sometimes it would power up but the menu and channel change did not work nor the volume.How can I determine if it is the TV and not the remote.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Most remote controls have a sliding door cover. I have attached a photo of a remote control which will guide you. where the 3 lines and the arrow are on this remote, this is where you need to press gently downwards and slide at the same time to remove the battery cover... unless you can see a single screw in the center of the remote which holds the battery cover on.
I hope this helps you. If so please leave a vote or comment.
good day... well you said you already replace w/ new battery..try to check the batt. terminals if still intact...if you can disassemble it to clearly check the wires.. if still good I suggest that you replace the infra red LED...goodluck
It sounds like the wall button has the lock feature engauged.
Is there a small green LED flashing inside the wall button?
Push and hold the lock button for about two seconds and the LED should stop flashing. This will unlock the garage door opener and your remotes should start working. You may have to reprogram your remotes and homelink again since you triedprograming in the lock mode.
Try the command code switch. I recently had a similar problem when my remote suddenly stopped working. It worked fine one time but nothing the next time I tried it.
I checked the emitter with a digital camera and found it was not working. I did the remote reset (remove batteries and push all the buttons twice, reinsert batteries) and the emitter was now working. However, the remote would still not control the base unit. I did the remote base code reset (push power, volume and TV/DVD buttons together) but this did not help. I then checked the command code switch. This is a small three position slide switch located in the battery compartment on the remote. I slid the switch back and forth several times returning to the default number one setting where it was before. I did not change anything on the base unit but the remote now worked.