Question about PC Desktops

1 Answer

Printer wont print when instructed to do so, although the green light is on at the righthand side of the printer.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 148 Answers

Is your application pointed to that printer?

Posted on Jul 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My printers and cash drawers (printers on the network) won't function. All of them work indivudually when test pages are printed. How do I get the network to see them?


please cheak the following


for printer to weork in the network you need network ,network printing sharing driver, or apllication of printer i.e. software you are using it should share the network.


please cheak the following thing

cheak if you have a network then rj45 cable is attached or not on computer side .cheak it is blinking grren &orange light. green is for power &orange light is for data transfer


cheak you have shared your printer driver for network printing



cheak your software is compatible with network printing or not



waiting for your reply

thanks &regartds
vijay p. patel

Apr 06, 2011 | ACM Supplies POSMicro Premier Retail...

1 Answer

My printer is offline. I have an HP deskjet 3930. I have tried unplugging, disconnecting, turning both printer & comp. off. The green light just keeps blinking. I've cleared all printing.


The green lights blink during the starting phase of the printer. If it doesn't stops blinking then the starting process never finishes, which means that the processor of the printer or the firmware circuit have failed. The only way to replace those is to replace the entire mainboard, and that would cost more than a new printer altogether.
This printer is dead, time for a new one.

Apr 03, 2011 | Gateway PC Desktops

1 Answer

HP4550 - 49.00FF service error


Turn off the RAM disk on the printer.

Follow these steps:

Troubleshooting steps

1.
Verify that the formatter light is blinking or steady. If the formatter is blinking, it is functioning properly and probably does not need to be replaced. If the formatter light is not blinking, proceed to Step 2.
2.
Turn off the printer and unplug the power cord.
3.
Remove the HP Jetdirect card, third-party device, hard disk, parallel cable, or IFR cable from the formatter if one is installed.
4.
If the error continues with accessories removed from the formatter, perform a cold reset on the printer. Ensure the HP Jetdirect card is not in the printer during a cold reset or the card settings will be changed back to default settings. To perform a cold reset, do the following:
1.
Turn on the printer.
2.
Watch the control panel.
3.
When the memory starts counting, press and hold the green (Select ) button.
4.
Continue holding the green check button until the Ready, Data, and Attention lights flash once, and then stay on steady.
5.
Release the check button when the Ready, Data, and Attention light are on steady.
The control panel will display SELECT LANGUAGE .
6.
Press (Down Arrow ) button once. The control panel will display COLD RESET
7.
Press (Select ). The printer will perform a cold reset and then continue its power-on sequence.
5.
If the printer comes up to ready, print a Configuration page. If a 49 error occurs from printing internal pages, continue on to the next step.
6.
Turn the printer off and unplug the power cord.
7.
Remove the eight screws around the formatter.
8.
Remove the formatter. See Figure 1.
9.
Reseat the firmware and memory modules on the formatter. Check for any DIMMs that are non-HP and remove them. Non-HP DIMMs are not supported by HP and may cause this error. Replace with HP DIMMs, if necessary.
10.
Reseat the daughter (interconnect) board. The daughter board is connected to the formatter behind EIO slot #1. To release the daughter board, push in the black retaining tab underneath the formatter then lift up the one side of the daughter board.
11.
Reseat the daughter board.

12.
Install the formatter.
13.
Turn the printer on again.
14.
If it comes up to READY , print a configuration page. If a 49 error does not appear from printing internal pages, or at power up, continue to the next step.

15
Install the HP Jetdirect card and hard disk before installing the formatter. Verify that each device is properly seated.
16
Test any EIO devices, by turning off the printer, installing each device separately, and printing a Configuration page. Repeat for each EIO device.
17
If the 49 error occurs with any EIO device installed, replace that EIO device.

Oct 05, 2010 | PC Desktops

1 Answer

Have dell xps 410 was on a network took it off now pinter wont


Click on HP's link http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?lc=en&dlc=en&cc=us&product=303756&lang=en& and select your Operating System. Then Download the driver for your printer. Follow the Instructions and Install it.

Oct 21, 2009 | Dell XPS 410 PC Desktop

1 Answer

Printer has good power connection but no response at all. i know power connection ok because page number light glows on printer


Install its driver. Or in printing que set the lexmark 2600 as the printer to be use. Then test print. Check its data cable.

If this doesn't help leave a comment so we can device another solution

Apr 15, 2009 | PC Desktops

1 Answer

GREEN LIGHT KEEPS BLINKING PRINTER DON'T PRINT


hi rudy, thank you for using fixya.

when you said a green light was blinking was it the power light or another green light on the printer?

i strongly suggest that you refer to these links to have it fixed if it is a blinking power light.

For instructions on how to clean the ink cartridges: http://www.fixyourownprinter.com/forums/printer/26642.
For a diagnostic procedure: http://www.annoyances.org/exec/forum/winxp/1073811565
For instructions on how to un-install and re-install the print drivers and other Lexmark software problems: http://www.techspot.com/vb/archive/index/t-10556.html

otherwise, we are looking forward to your reply.

regards,

voodoo

Apr 14, 2009 | PC Desktops

1 Answer

Canon 4150 wont print , goes into queue


Have you gone into the queue and deleted the print jobs and started again? Do you have any error lights? If so there could be a hardware problem with the printer.
Try taking out the toner and putting it back in. Sometimes that will force the printer to reset intself.
If that doesn't help then you may have to delete the printer from the system and re-install it.

Apr 13, 2009 | PC Desktops

1 Answer

My printer will not print. c3180 all in one


try to print a self test by unplugging the data cable from the system and turn off the printr and hold the green light button and turn on the printer and then relesed it it should print the test page try uninstalling and reinstalling the drivers

Regards
Samson Ved

Dec 05, 2008 | HP PC Desktops

1 Answer

I need to print a programme on microsoft publisher without the white border around the outside so basically full page but it wont do it any ideas


Maybe it is a printer limitation. Some printers just will not print full pages, even if you set the margins to 0mm on all sides. Try other printers.

Oct 12, 2008 | PC Desktops

1 Answer

My printer is not printen


have you been printing with it before? check your catridges to see if you have ink, the printer has a light on it's face which says online, is that like showing green b4 you start printing, if not so check your cables and make sure they are firmly fixed. check for paper jams, if all these don't work reinstall the drivers, from the cd which came with printer

Aug 14, 2008 | HP PC Desktops

Not finding what you are looking for?
PC Desktops Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top PC Desktops Experts

joecoolvette
joecoolvette

Level 3 Expert

5660 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18299 Answers

Are you a PC Desktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...