My ac is always changing itself to fan mode...and it beeps all the time. i tried to change the mode and it will change it back to fan. Please help...i havent had a good night of rest because of the constant beeping.
a 6ya Repairman can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Repairman (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I understand that your Frigidaire air conditioner, model# FRA124HT2, begins with a constant beeping, and changes the modes itself, about every 30 minutes. I also see that it ends up on a different setting each time it does this. I suggest resetting your air conditioning, by either unplugging it or shutting the power off at your home's circuit breaker for 3-5 minutes. Bring power back to it and turn it on. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your washer status has changed successfully. Hope this is helpful.
Doesn't have a resistor. It has a blower motor control processor. When they go bad, the blower motor defaults to always on (go figure that logic). Pull the AUX blower motor fuse until you can get a replacement. The processor is located back by the rear blower motor. Blower motor wont shut off Ricks Free Auto Repair Advice
1).Try Booting up in F2 use safemode in thin make the change Safe mode is a diagnostic mode of a computer operating system (OS). It can also
refer to a mode of operation by application software. Safe mode is a way to troublshoot problems.2).Try geting NVIDIA Graphics Driver 301.42Help Restore Defauits allow you to preview changes you make to the image and rending setting this will be your defauit setting for your hardware accelerated 3D application that utilize Direct 3Dor open GI.
you have to go in to the proramming mode of the remote to change this feature. you can access this by holding all 4 buttons on the remote at the same time. (or if you have the P button on the back you can hold it down by itself) you will hear 2 long beeps confirming the programming mode. at this time, you can change the settings by pressing 1 of the 4 buttons., each button will change a different function.
in no order------
1. Beep/vibrate or both
2. page or not to page
4. hood, truck, or both
the remote will give 2 long beeps when it exits the programming