G five on off switch is not working - Cell Phones

hi, as a retired auto elec.tech and installer, its been my experience that one of the door switches are bad. gm uses two types of systems. a 3 wire, and five wire. if you can access the back of the switch and see how many wires are there, and if its five, the voltage uses both switches to make the motors operrate. if there is three wires you would have to check the voltage on the orange wire at the switch. if its there, you you may have a wire or relay. hope that helps.

The switch is in lockout mode master switch. On the switch is five button one for each window and a five the lockout

It's a NuTone household fan.
Five conductors usually means five wires, though for example two of the same may be for the same purpose, 0V eg.
The fan also contains two lights. The control of fan and lighs delends on how you choose to wire it up. -
"?For?separate?control?of?fan,?light,?and night?light?three?wall?switches?are?required.?See?NuTone?Catalog?for?accessory?switches.?For?separate?control?of?fan,?light,?and?night?light,?five?conductors?are?needed?between?the?wall?switch?box?and?the?fan's?junction?box" (p1 of manual, below)
For instructions on wiring see manual for example here NuTone 8663RP Installation Instructions Manual p2
12.February.2015

I believe the problem you do have with your auto-transmission,is with the electronics,probably with ECU of the gear box. By switching off the car and restart and the gear box works for five minutes and then the same thing again from the beginning, is like by switching off you do clear and reset the program of your ECU.
It is recommended to apply to a qualified Garage for a better and safe repair.
Good Luck.

Check that the remote is working. Do this by using a digital camera and point the sender at the lens . If it is working you will see a blue/red dot on the viewer screen. It will move when you move the remote. You cannot see the beam but the digital camera can and shows it up on the view finder.

without being able to trouble shoot the switch i don't have a solid answer for you but I would guess that the resistor in the switch burned out and a new fan switch should take care of the problem. good luch

Hi, kindly unplug the unit for five minutes. this will drain all power, and reset the main board. Once the five minutes have passed, simply plug the unit back into the power outlet. If the problem continues, the touch pad should be replaced asap.

with ignition turned on, using the trip switch , change the display to ODO, and then turn the ignition OFF
While pressing the trip switch,turn the ignition switch ON and hold for five seconds
Release the trip switch,then press the switch again within five seconds.The digital display should change to T- BELT MODE. Each press of the switch then should change the reset time by 10,000km increments. After setting the klms hold the trip switch ON for more than five seconds then release the switch. Check that the display has now changed back to ODO and that now the warning has gone off when the engine is started .

The HP Procurve 2650 switch does not have buttons. What hardware has the problem?

yes is safe you probably got the ignighters switch's wet if one is wet will cause all to fire after awhile they dry and return to normal