My digital washing machine is spin drying but refuses to wash. It attempts washing by spinning 4-5 times and then it suddenly stops

mak sure u manally spin it 4 a sec 2 kickstart the engin

I have washer Model # XQB60-91BF It do all functions eccept spinning when it comes on spinning drum does't rotate. I replaced drain pump but does't spin. Can you guide me about trouble.
Thanks. email: [email protected]

UPLOADING OR FRONT LOADING WASHER..........CHECK ITS BALANCE LEVELS.

my washer stops at a rince cycle and wont drain to spin dry

SUDS DETECTION

During Drain Routine

During the Drain Routine, the water level is checked continuously. Normal drain will occur until the

pressure switch senses no water in the wash tub and there is no foam (suds). The drain pump will

operate an additional 15 seconds after the pressure switch reports no water or foam.

If the drain routine operates for four (4) minutes and the pressure switch senses any foam (suds) in

the wash tub, the Central Control Unit will start the "Kill-Foam" Routine. (See description of this

Routine below.) After the Kill-foam Routine is concluded, the Drain Routine will restart. If, after

four (4) minutes the pressure switch still senses foam in the wash tub, the Central Control Unit will

go into Failure Mode. The digital display will show, F02.

During Spin (Extract) Routine

During the Spin/Extract Routine the water level is checked continuously. If, during this routine, the

pressure switch senses the presence of foam (suds) in the wash tub, the Central Control Unit will

stop the drive motor and the basket will stop spinning. The electronic control will count the number

of spin repetitions that are attempted due to foam (suds). There are a maximum of three (3)

attempts for each Spin/Extract Routine.

Kill-Foam Routine

1. The Remaining Time counter is stopped.

2. The digital display shows Sud.

3. The Drain Pump is turned OFF.

4. The Central Control Unit will fill the wash tub with 1 gal. (4 L) of cold water.

5. While the tub is filling the basket will tumble 1 sec. ON/15 Sec. OFF.

6. Once the tub is filled, the drive motor will turn OFF and the basket will rest without any

movement for five (5) minutes.

7. After the five (5) minute rest, the remaining time counter will restart and the digital display

will show the remaining time left in the routine.

NOTE: If the Kill-Foam routine was initiated during a Spin/Extract Routine, the tumbling action

will be reduced to a cycle of 3 sec. ON/13 sec. OFF. If, at the end of either the Drain or Spin/

Extract Routines, a suds condition still remains, the digital display will show Sud.

Sud will also be displayed for a short period at the end of a cycle, if a Suds condition was

detected during the cycle. This will alert the consumer to reduce the amount of detergent in
subsequent uses.

This sounds like it could be a faulty door lock switch. The switch can be tested for continuity using a multimeter. A lack of continuity indicates a faulty switch. Hope this helped and best wishes.

sounds like your spin cycle belt has come off or broken. it,s a simple fix at a repair shop.

unplug for 40 minutes in an attempt to reset the ECU.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

I have inherited a hoover saver 1300 in new flat, the dials have worn away and it goes onto drying mode after wash, how can i have it on wash and spin only - NO DRYING? Thanks

Open machine's service panel and check whether the motor spins. Let us know with your results and we will see how could we assiste you further.