Wanted electrical diagram for kelvinator dishwasher kd12ww

You can try resetting it by unpluging it or shuting it off at the breaker for 5 minutes.

We are a repair advice website so we cannot always provide actual documents and manuals. If you are having a serious enough issue to need a wiring diagram it would be better to get a specialist repairer look at it as they will have the knowledge and tools to repair you machine.

check the link below
https://www.google.com/search?q=Kelvinator+dishwasher+KD12DSS-2+error+6&oq=Kelvinator+dishwasher+KD12DSS-2+error+6&aqs=chrome..69i57&sourceid=chrome&ie=UTF-8

That is either not the whole model number or it is not correct. There maybe a float switch in the machine that is sensing a high water level and is shutting the machine down. It is impossible to tell without the right model number.

Most all dishwashers have what looks like a air hockey striker. This is the float. It should move freely up and down. Not to much travel.
Next would check for a faulty water inlet valve.
These in my opinion would be the two most likely culprits.
I hope this information will help you! Have a blessed day!

I found a site that is important for you to down load the site is ns323666.ip-37-187-156.eu
It is a pdf version of the instruction manual for the dishwasher
I notice that one of the instructions is quote" when using your dishwasher , you should prevent plastic items from contacting the heating element" un quote
most all dishwashers heat their own water above what human hands can stand so from that statement you can use cold water inlet only and the machine will heat it to operating temperature
I got that site by going google and typing in --kelvinator kd12ww dishwasher
then I selected site manual-kelvinator kd12ww dishwasher clicked on that and that address came up with the pdf manual
there are other sites that have parts manuals and heaps of other information
call your local kelvinator service agent and ask them about a heating element

Need to check if Rinse Aid is not exhausted in the dispenser. It could also be necessary to increase the flow rate of rinse aid. Also make sure the dishwasher is heating water as some dishwashers use steam to dry. If heater is faulty the steam will not be there.

There's only 2wires and it shouldn't matter which terminal on the cold control u connect it to. If there's 3wires one should b green and it's a ground wire