Can't find Power and Speaker Plugs For Mb Quart RAA1000 1975 mono block Car Amp.

The Soundstream Class A 5.0 will deliver its full power at 1 ohms mono.
I think your subs are two dual 4 ohm voice coils.
If you wire the voice coils for each sub in PARALLEL, that's 2 ohm for each sub. To get 1 ohm mono, you need to hook up the subs in PARALLEL to the amplifier, in bridge mode. That's the way to get to 1 ohm mono. Please add a fan to your setup as the amplifier will get very hot. You will need to use a relay to hook up the amplifiers and fan(s) to or you will damage the remote ouput of your HU (if you hook up the fan straight to the remote of the HU) as the remote output of the HU is not designed for the amount of current a fan draws.
Good luck. If you need help with the relay issue, have a look here: http://www.caraudiohelp.com/newsletter/multiple_amplifiers.htm

Hi,

I am assuming you are referring to the actual connectors/plugs that are needed to wire the MB Quart RAA1000, a complete wiring kit is available here. It includes patch cord, power cable, grounding cable, turn-on lead among others.

If you want a pictorial layout of the wiring and connectors, the owner's manual would be of help and is available here.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

4 ohm voice coil? on the mono amp it should be from left to right ++ -- you want to go + x x -

Hello danielperez9,

There are two options for wiring a single 2ohm DVC subwoofer to a mono amp. The first gives a 1ohm load and should only be used if your amp is stable at 1ohm. The second option results in a 4ohm load and would be OK for most amps. Here are the diagrams:




Hope this helps.

Most electronic stores carry these, radio shack, circuit city, best buy. One thing, when buying the power wire, make sure the guage is right for the wattage.. to small of a wire may hinder the performance of the amp. 
Ciza

I think it was custom made for MB Quart. Have you tried contacting the, to see if it is still available?

I have a mbquartz 2500raa. If its a bridgable amp take each wire individualy and sauder each wire at the end into a ring large enough to fit around the plug ti area. When connected if sound is produced sauder each looped wire end to the plug area. Make sure to cover each wire with electrical tape so as to keep from arcking this is what i did with mine when i lost the plug.

maybe the equilizers messed up

You will bridge the amp, and if the subs are all 8 ohm subs, you can probably wire them all in parallel, if they are all 4 ohm subs, you would wire then in series.

Dam Jaggy87, I think I would let them hold the amp and go somehere else. I would not want someone who doesnt understand putting anything in my car.

 

The Plugs may be Speaker level and Line level input.