Question about Recoton Advent Advent 900 MHz Wireless Outdoor Speakers, AW810 Set of Two Computer Speakers

Open Question

I have a RECOTON wireless speaker that has quit speaking. I do get the RF light that says it is tuned. The speaker did work for a while then started buzzing and then died. I figure a component in the amp quit. Anyone have a schematic. It is model W400 RX, 1682-K1169, CLV-A900R. I am not sure just which number is the right one to ID the schematic. Any Help

Posted by on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: Spkrs quit receiving signals

Hi, assuming you can open the enclosure of the Advent, work on the amp section (please make sure you've isolated the power supply and you will be working with the low voltage section of the circuitry only.) Inject an audio signal, it does not matter where in the amp section, just try the different solder points of the small capacitors normally in the 1uf value. at least one of them should give you a good amplified output from the speakers. In the absence of a signal gen, you may want to try (with care)using your bare finger which should produce a humming sound of about 60HZ or a slight thump in the speaker. If such a sound is produced, then the amp is good and the powersupply is doing its work. You have now isolated the problem to the 900MHz receiver. Am not sure if you can purchase modular replacement in your area but you can also try the sig gen or finger method except for the front end (rf section). Re the humming sound, such a problem is normally related with the power supply section with a defective or leaky capacitor. It is also possible that the input stage of your amp is not grounded right. You actually have just to work on it in stages to simplify fault diagnosis. Since you can hard wire, why not try salvaging parts/module from one unit and putting it in the other to make at least one working while looking for replacement parts/module for the other half of the Advent. Hopes this work out for you. Please let me know how things turn up. Regards

Posted on Apr 11, 2007

Ad
  • 14 Answers

SOURCE: Popping sound in the Rocoton Advent Wireless speaker

Double check your connections at the transmitter. Swap inputs to see if the popping moves to the other speaker. Popping usually means blown, however......

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Logitech wireless rf keyboard and mouse quit


Hi,

To fix the problem,
please press the connect connect button on the bottom of the mouse and the connect button on the reciever and relaese both the buttons together. this would rest the wireless connection and then the mouse should work fine.

regards.

Jan 28, 2010 | Logitech Wireless Access Duo Optical...

1 Answer

Popping sound in the Rocoton Advent Wireless speaker


Double check your connections at the transmitter. Swap inputs to see if the popping moves to the other speaker. Popping usually means blown, however......

Dec 13, 2009 | Recoton Advent Advent AW810 Main / Stereo...

4 Answers

Recoton w500 wireless headphones


I have the original "Installation & Operation Instructions" for the W500 wireless headphone system.
Send me your e-mail address and I forward a scanned copy if you want so.

Sieg

Dec 03, 2008 | Audio Players & Recorders

1 Answer

Brookstone Wireless Rechargeable Speakers with auto-tuning


its probably the interference with the routers. try getting internet by bypassing the router. much easier sound quality.

Jun 12, 2008 | Brookstone Outdoor Wireless Speaker...

1 Answer

HOOK UP


Hi there!

If using an RF Converter you will have to tune whatever you connect to it onto UHF Bandwidth until it locks. You would tune it like you would tune any other station. So as an example tune a tv station onto CH1 and the DVD onto CH2 etc. Regards and good luck. JUS004

Apr 01, 2008 | Televison & Video

1 Answer

Recoton Wireless speakers


where can i get a new battery for recoton w 410

Dec 17, 2007 | Sony SA-IF70 Speaker

1 Answer

Advent AW810 Wireless Speakers


Turn your tv speakers off via setup.
You can't run both tv & audio out on any tv I have seen.

Sep 20, 2007 | Recoton Advent Advent AW810 Main / Stereo...

1 Answer

Spkrs quit receiving signals


Hi, assuming you can open the enclosure of the Advent, work on the amp section (please make sure you've isolated the power supply and you will be working with the low voltage section of the circuitry only.) Inject an audio signal, it does not matter where in the amp section, just try the different solder points of the small capacitors normally in the 1uf value. at least one of them should give you a good amplified output from the speakers. In the absence of a signal gen, you may want to try (with care)using your bare finger which should produce a humming sound of about 60HZ or a slight thump in the speaker. If such a sound is produced, then the amp is good and the powersupply is doing its work. You have now isolated the problem to the 900MHz receiver. Am not sure if you can purchase modular replacement in your area but you can also try the sig gen or finger method except for the front end (rf section). Re the humming sound, such a problem is normally related with the power supply section with a defective or leaky capacitor. It is also possible that the input stage of your amp is not grounded right. You actually have just to work on it in stages to simplify fault diagnosis. Since you can hard wire, why not try salvaging parts/module from one unit and putting it in the other to make at least one working while looking for replacement parts/module for the other half of the Advent. Hopes this work out for you. Please let me know how things turn up. Regards

Apr 09, 2007 | Recoton Advent Advent AW820 Computer...

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

373 people viewed this question

Ask a Question

Usually answered in minutes!

Top Recoton Advent Audio Players & Recorders Experts

Ron Rak
Ron Rak

Level 1 Expert

47 Answers

NOEL
NOEL

Level 3 Expert

7561 Answers

Tom Chichester

Level 3 Expert

35737 Answers

Are you a Recoton Advent Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...