Question about Cobra 200 GTL DX 4-Channels Base CB Radio

1 Answer

I have a 200 gtl dx and its got a short in it somewhere it wont reach but about 100 yrds but if i put pressure on the top and bottom it works great need to find out what it is

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Cobra Expert
  • 500 Answers

Unusual for that radio to do that since is has such a small board. but if you need help let me know.

Posted on Jan 03, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do you have bullet drop for the 450 Bushmaster


From a friend - All bullet drop depends on the bullet weight, load and barrel. So, a 450 bushmaster with 20" barrel on it and done some work with it the past few days. After some trouble dialing in the scope multiple times I finally got it on at 100 yards. With a 100 yard zero (around 1.5" groups which isn't too good but I believe it is due to my scope which is going to get replaced shortly) we shot it out at 300 yards to see what it would do. We calculated the drop to be approximately 30" with the 100 yard zero. First few shots we were not on paper so we raised hold point up a few inches and we had our first mark. After 2 more shots we had a group to measure from. Back at the house we measured the 3 shot group at 300 yards to be 7.5 inches. (again I am confident this can perform better with a better optic) and 37.5" low. With a 2000 fps velocity and 250 gr bullet from Hornady, it puts the ballistics at

100 yrds- 0" drop, 2030 ft lbs energy, 1912 fps
200 yrds- 9.5" drop, 1067 ft lbs energy, 1386 fps
300 yrds- 37.5" drop, 760 ft obs energy, 1170 fps

Oct 03, 2017 | The Optics

1 Answer

Hi need to adjust the echo delay on my cobra 200 gtl dx !


Open your radio and, with a small flathead plastic screwdriver, adjust T713. Any other questions feel free to ask.

ironfist109_17.jpg

Jan 19, 2011 | Cobra 200 GTL DX 4-Channels Base CB Radio

1 Answer

200 gtl dx has no output but still recieves,who works on these


Known bugaboo with these radios, weak design in the RF amp. Needs to go to a good shop. Email me...... poikaa@yahoo.com

Feb 02, 2010 | Cobra 200 GTL DX 4-Channels Base CB Radio

1 Answer

Gtl dx will not transmit below 26.955


First off, the 200 GTL DX is a 10 meter radio. Running it on 11 meters (CB) is illegal, as it is not FCC type accepted. If you go below 26.965 mhz, you are outside of the 11 meter band, and operating illegally.12 meters does not start until 24.930, so ultimately, the freq's between 24.930 and 26.965 mhz are restricted even to a licensed amateur radio operator.

Jul 09, 2009 | Cobra Radio Communications

1 Answer

Cobra 200 gtl dx audio output


Could be the jumper on the back for hooking up external speakers fell out.

Jan 27, 2008 | Cobra 200 GTL DX 4-Channels Base CB Radio

1 Answer

Cobra 200 gtl dx


Could the battery be dead? Other than that, it may be a bad solder joint inside the mic.

Geno

Jan 24, 2008 | Cobra 200 GTL DX 4-Channels Base CB Radio

1 Answer

Question about my cobra 200


no need to increase power output. you can take a radio with 100 watts and a radio with 10 watts that had had a modulation kit installed and the 10 watt radio will out talk the 100 watt radio ALL day long. the best thing to do would to put a mod kit in it and have the dead key cut back to 1/2 watt then put as little amp behind it. with those mods it will be loud and clear. hope that helps

Dec 30, 2007 | Cobra 200 GTL DX 4-Channels Base CB Radio

Not finding what you are looking for?
Cobra 200 GTL DX 4-Channels Base CB Radio Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cobra Radio Communications Experts

Brad Brown

Level 3 Expert

17326 Answers

Steve

Level 3 Expert

3289 Answers

yadayada
yadayada

Level 3 Expert

80417 Answers

Are you a Cobra Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...