Question about Mitsubishi WS-55809 55" Rear Projection Television

1 Answer

Wont turn on. on light comes on for 5 seconds then shuts off

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mitsubishi Master
  • 14,553 Answers

Do the self check this model has.

When power light goes off on the front of the set press and hold both the menu and input (device) at the same time and hold for at least five seconds and release both buttons.

The power light will blink a two digit error code: like 2 blinks, 2 blinks, a pause and then repeat it several times.

Let me know by leaving a comment here what code you find and I will tell you what it means.


SD TECH

Posted on Jan 01, 2011

  • 1 more comment 
  • jrsmith28 Jan 03, 2011

    2 blinks pause 2 blinks

  • SD Tech
    SD Tech Jan 03, 2011

    98% chance one of the two pico fuses that protect the convergence circuit is blown, set detects no voltage and 2-2 is short protection.

    See attached photo of fuses

    The model indicated uses two of the STK-392-570 Convergence chips, both and the fuse will have to be replaced, best way is to remove middle board.

    IF NEEDED I HAVE START TO FINISH, STEP BY STEP INSTRUCTIONS FOR THIS REPAIR IN THE MODEL INDICATED.

    Total parts cost on Ebay would be under 30 dollars!

    The instructions tell you everything you will need and exactly how to do it, it involves getting at the chips and being able to solder.

    Look at photos and if interested we will find a way to email the instructions to you for free.

    SD TECH















    First photo shows some resistors in front of chips that need to be looked at, easy.

    Second photo shows the fuses, note the two circled, they are to be looked at first, one will be open or bad.

    Third photo shows a typical chip, yours would have the STK-392-570 numbers on them, your model indicated uses two chips, both and the fuse must be replaced.




  • abergop Apr 15, 2011

    this is exactly my problem--have been looking online for a solution for hours. please send instructions to abergop (at) yahoo (dot) com

    thank you!!!

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1993 nissan sentra 1.6 wont run and check engine light wont turn on,bulb is ok


Could be any of several things. If the crank sensor is marginal and not sending pulses, the fuel pump is shut off. This is for safety. The pump is energized for a few seconds as key is turned in preparation for starting then engine must rotate normally to keep the pump on. If it stops, in a few seconds the fuel is cut off.

Aug 17, 2012 | 1993 Nissan Sentra 4 Door

1 Answer

My hp notebook just shut off,wont come back on


Sounds like a burnt out capacitor. Either on motherboard or power supply.
You can try taking out battery, press and hold power button for 5 seconds, put back in and try to turn on. If it doesn't turn on, then I'm afraid motherboard is bad or memory card is faulty

Nov 11, 2009 | HP Pavilion dv2610us Notebook

1 Answer

DC 17 UPRIGHT BRUSH MOTOR WONT STAY RUNNING. TURN


have a look at the filters first as it sounds like you blokeage

Oct 31, 2009 | Dyson DC17 Animal Bagless Upright Cyclonic...

1 Answer

Dometic ndr 1292 wont turn on


All domestic refrigerators have a overload protection and it sounds like the overload is kicking in. It wont start right back up to protect the compressor.

Mar 27, 2009 | Dometic NDR 1292 Refrigerator

1 Answer

Problemith 50gx30b


You want get information for free but you don't want give information for free?????????????????

Dec 19, 2008 | Hitachi 50GX30B 50". Rear Projection...

1 Answer

No picture sound is fine


tv comes on then turns blue at that time it shuts down. The power is on and then it blinks 5 times!!!

Apr 27, 2008 | Sony KP-65WS500 65" Rear Projection...

2 Answers

RCA Television D52W14


IF you would like help diagnosing your set. Go to the enclosed link. They have the service manual for your set and offer unlimited chat support for only 29.99. Just click on your sets manufacturer and you will see your model. Then click on the contact us link and provide your email address and they will email your manual and instructions on how to obtain your support. I am one of their techs. This manual contains step by step procedure for troubleshooting Your RCA DLP Light Engine
http://servicemanuals.vstore.ca/

Jan 08, 2008 | RCA HD50LPW175 50" HDTV

Not finding what you are looking for?
Mitsubishi WS-55809 55" Rear Projection Television Logo

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1208 Answers

The Knight
The Knight

Level 3 Expert

73619 Answers

Jaime Hernandez

Level 3 Expert

2315 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...