The panel went black- no display of clock, temp, etc. The oven doesn't heat up. the light weorks inside the oven

LED clock/temperature light fading an - Appliance Repair Forum

forum.appliancepartspros.com/oven...ranges.../650-led-clock-temperatur...

Aug 20, 2007 - 3 posts - ‎3 authors
The LED clock/temperature/etc control light has been becoming less ... needs to be replaced (board being the oven clock/erc/control board). Control pad temperature light out
2 posts
Jun 15, 2014
Dim temp lights
2 posts
Feb 7, 2014
Frigidaire range LED display is dim
10 posts
Aug 28, 2009
Oven clock & light
1 post
Jun 21, 2009
More results from forum.appliancepartspros.com

Cheap Fix for a Dim Display on an Oven Control Panel ...

Check for the fuse on the panel board.

in cleaning a pyrolitic oven is suppose to lock the oven door , this is a safety feature due to fact that oven gets up much higher in temp than a normal oven , the heated air it produces if let out would flash burn anything in front of it to ashes (people,pets,rugs,etc.) the clock doubles as your display window to see what temp oven is at , there should be a clock selection to see current time of day even if oven is in use , and last but not least , it has a delay cleaning start feature , you can set it to come on and clean it's self , Id recommend not to use this feature for safety reasons (I don't think the mfg thought that feature out too much )
the door should remain locked till oven temp is below a preset minimum safe temp ,id not force it open for safety reasons

How many active terminals are there at the main terminal block in the new oven. Is this a single or 2 phase supply. Have you connected the active supply to all active terminals. If only half of the oven is working it sounds like it could be a problem at the terminal block. If so, you need to put a loop or bridge wire to the 2nd active terminal.
If all this was done correctly when connected the only other thing it could be is the electronic clock needs to be set to manual mode for the oven to work correctly.

it may have back lite lcd display and the lights have blown shine a torch into the lcd if you can read it then you need the backing lights replaced

its the display theat is fading away. I've haad meter's do the same thing after awhile and there's nothing you or I can do. Thanks for using Fixya

I found the manual online. Apparently my unit is malfunctioning and should work by just pressing bake temp and then selecting the temp...

reset your breaker reprogram the clock try again what happend last time it was working self clean broiling etc

there is a dispay kit you can order from bosch to fix this problem. it will come with a new display board and power control which is located behind control panel as well

Check power going to the electronic module in back of the display. If power there you have a blown module. If no power check for a blown thermal fuze.