My Phillips PSS110/05 has been very useful when teaching exercises in my classes for the over 60's as opposed to the alternative that I had been using i.e.Loads of CDs and a MusicCentre to carry around.
Two weeks ago the MP3 Player suddenly would not respond, the battery was charged and in due course I called in Comet where I had it from and was told that the internal battery was no good and that it could not be repaired.
Is this So?
Alternatively is there anything on the market that could replace this model?
Have you checked the reset button at the back - I have had to reset my unit more than once. Battery is probably OK. You can send unit back to Philips to have new battery installed - but I would bet your battery is OK.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Use a pen tip or other sharp object to insert the RESET hole on the side of the player.
Here is a page which shows you how to transfer music over to your new Phillips Media Player. Windows Media Player sync is specific to Windows products. Do NOT use this to transfer music to your Phillips media player. Use the software supplied by the manufacturer.
If this solves your problem, please come back and rate our solution. Thank you.
you may need windows xp sp2 because I had the same problem and I had to install windows xp sp2 because with sp3 which I had at the time I purchased the device it did not want to work. It is said in the manual that you need windows sp2 for it to work and be recognized.
Make sure the GoGear is disconnected from the computer first. Hold in the volume + button, and continue to hold the volume + button as you reconnect the GoGear to the PC. Once connected, after continuing to hold the volume + button for up to 60 seconds, Windows will go into recovery mode and resuscitate the GoGear.