When redialing a missed call how do I add the missing 1 before the area code? I have missplaced my user manual.

N70 restart problem
Format User Area* or manual format YES+*+3+ON ?
*#7370#

You can download the User Manual from here

If your Problem was resolved, Kindly Do Rate.
And a testimonial would be much appreciated.

Regards, WAQAR.

I can't redial.. How do I set up my phone to redial an automatic 1 before the number I want to dial? i have a GE digital 5-8

Ifyou go to the HP website all the nessasary drivers and manuals are available for down load. I have included a link for you to follow.

http://www.hp.com/#Support

Hope this is of some help.
Ed

I had the same problem with my phone. Tried a lot but couldnt fine the solution.

User Programming Mode
�� To enter User Programming Mode, press the Program button ...or dial #9876. "USER PROG MODE" appears on your LCD. The Program LED is steady green. �� To exit User Program Mode, press Program … or go off- and on-hook press #9876. Note A IPT equipped with a headset adapter ignores the hookswitch. It can only exit User Programming by timing out (approximately 15 seconds).

Redial is used by pressing the redial button to access the stored numbers, each press brings up another number. To dial the number you want hit the # key. i.e. to dial a number you called 3 phone call ago you press 'redial', then 'redial', then 'redial' followed by '#'.

You will need to customize your Call log settings to show which area code your located in so it will redial from the log properly. To do so, push Menu, then scroll to system settings, push select, then scroll to Area Codes, push select and specify the area code that you are in. If you need additional assistance, go to the link below which is the full manual on PDF, then go to page 48. Hope that helps. http://www.barclayent.com/manuals/Gigaset%202420%20Plus_guide.pdf

Hi Mike,

Its an easy fix, you need to tell the phone what area code your in. Push menu, go to system settings, enter your pin, scroll forward to "area codes" press enter twice, enter your area code and push enter to save. Now the phone knows where your located and wont add the 1 and the area code. CG

See below for complete instructions but think you have missed out part 2......

Reregister the handset or add additional handsets.

1. Remove all handsets form charging or Main base unit.
2. On on Main base unit, press and hold Page button for 10 seconds until beep. ( Not paging beep )
3. On 'unregistered' handset press and hold Redial & Calls buttons ( Top left and top right ) until 'bs-' appears.
4. Enter handset number ( eg: bs-1 ) then the pin number( could be 0000 but check your manual ).

Cheers
Monty