Question about Price Pfister Ashfield Single Control Lavatory Faucet ...

1 Answer

Re: single handle lav. Ashfield: cold water flow is fine; hot water flow severly restricted. Have disconnected supply tube and flow is fine into a bucket so it is not a problem with valve or supply tube. What can I do?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have the same problem with my Ashfield faucet.
I am going to contact Price Pfister and try to get a new 'cartridge'.

On another note, my Ashfield towel rings are also broken. The connection where the two pieces meet is so weak it cannot handle daily use. I am going to bring this up with Pfister as well.

It doesn't seem like Price Pfister has very good products.

Posted on Jan 05, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just had a new price pjister series 40 (Ashfield collection) single control lavatory faucet installed. Our contractor installed it yesterday and he is now out of town for a week. Since the sink and...


You have already checked the two obvious things now make sure the two supply lines from the shut off valves are not kinked or turned it such away as to close off the water flow. If that is ok then there may be some debris in the internal filter screens.

Keep in mind that this faucet design will not put water out at a high pressure if it did it would splash all over the place.

Mar 08, 2011 | Price Pfister 042-YP0E Ashfield Single...

1 Answer

Hot water side of a 42 ashfield faucet allows very little water flow. I think it is stopped up, It stop when I change a hot water heater


You will need to take the faucet apart and clean it out. If the faucet is a few years old I would just replace the cartridges and be done with it.
When the water heater was replaced the lime build up in the piping was dislodged and I bet the faucet you are having a problem with was the first faucet used after the new water heater was installed.

Mar 04, 2011 | Price Pfister 042-YP0E Ashfield Single...

1 Answer

I HAVE A SINGLE HANDLE HIGH NECK BLANKO KITCHEN FAUCET THAT IS RESTRICTING THE FLOW OF WATER WHEN TURNED IN THE HOT POSITION. THE WATER IS FLOWING FINE IN THE COLD POSITION BUT WHEN TURNED TO HOT...


If water come out the faucet hot line,check if is clogged.For this job you need to disassemble the faucet.

Here is a good PDF source to do it.

If you need more help come back.Post / thumbs / testimonial are welcome!

Nov 12, 2010 | Blanco Classic Single Handle Faucet with...

1 Answer

Get hot water only....when rotated to cold get nothing....replaced cartridge but still the same.....shower has been unused since house was built


If you don't have easy access to hot and cold line, where you can disconnect and check for flow to faucet, You can try turning off incoming water supply, remove cartridge, and shut off hot outgoing at water heater, then slowly open incoming (cold) water supply only and see if cold flows from faucet with cartridge removed. At least that will confirm flow faucet, then go from there.

Sep 19, 2010 | Moen & Posi-Temp Single Handle Shower Or...

2 Answers

Just purchased the Price Pfister 42-YP. The hot water has limited water - just a trickle. What can i do to adjust?


Hi, David pressuming the water flow was good before you put in this new tap, then other than a problem with the tap! have you checked if you have an isolater valve on the pipe work under the unit, if so check that it is fully opened?
Thanks Paul.

Aug 31, 2010 | Price Pfister 42-YP0E Ashfield Single...

2 Answers

New Price Pfister Ashfield Bath Faucet - Hot H20 pressure is weak


I had the same problem. I simply removed the small brass fitting that the water supply screws onto.i removed the screen that is inside the brass fitting. Now the pressure is fine.

Feb 15, 2010 | Price Pfister Pfister Ashfield Wide Satin...

1 Answer

I have very little water press on the hot water side


Dis-assemble the faucet to get to the valve. The handle comes off and you access the valve from the top, usually by removing a screw on ring.

You will robably find contamination in the hot side of the valve.

You can find instructions on the Moen website.

Sep 09, 2009 | Moen 7310 Legend Single-Handle Kitchen...

1 Answer

No cold water from bathtub fixture/Shower won't engage


If you put on the cold and Nothing at all comes out, check the water supply valve to the tub. If it comes out alittle ...the washer probiblly came off and is stuck you will have to remove the valve ,but 1st check that the handle is not stripped ,and that is actually moving the valve to the open position Turn the handle and see if the handle backs out ,like its trying to open.
Please rember to leave me some positive feedback if Ive been Helpful! Thanks !

Dec 15, 2008 | Price Pfister Ashfield Single Control...

Not finding what you are looking for?
Price Pfister Ashfield Single Control Lavatory Faucet ... Logo

645 people viewed this question

Ask a Question

Usually answered in minutes!

Top Price Pfister Plumbing Experts

bwbconstruct

Level 1 Expert

23 Answers

john h

Level 3 Expert

12170 Answers

TED

Level 1 Expert

23 Answers

Are you a Price Pfister Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...