Started out with paper, would start to load paper them as soon as paper stared in would stop. After several tries it would work. Then it stoped taking paper at all. Each time you try to print it stops and light comes on to load / remove paper. This painter was bought new my me and has do very little printing at all but is a few years old.

You should take the car into a dealership for inspection. A guess is that the heater core started leaking coolant and that has shorted out the blower motor.

Sometimes spraying shredder oil on the cutting teeth wil work.

You should shred paper with a light weight machine oil poured on the paper to keep the cutting teeth working freely.

Good luck.

P.S. If this doesn't work then just take the head off and cleanj/lubricate any bearings you find.

If the car is dieing on you as you drive and it has to set a bit, Most likely your fuel filter is stoped up. As you drive it stares up all that crud in the filter and the suction will pull all sedaments untill its stoped up. once it is turnd off the pressure is released and always the sedaments to settle untial you try to drive again

I hope this is helpfull

get the alternator checked. if it is ok then check the tune up of the car.

it sounds like the fflame sensor needs to be replaced, however if the unit has fan assited combustion you may also have an issue with the pressure switch. hope this helps

I cant print...orange light under alarm keeps flashing...please help...patricia

Try turning the paper around. Some times the corners of the paper get slightly bent and the paper wont load.If turning the paper around does not work, switch your paper. Hope this helps.

hello!

have you tried cleaning the separator pad inside the automatic document feeder?

try to Load one or two sheets of unused plain white full-size paper into the document feeder tray, and then press Start Copy Black to pull the pages through the automatic document feeder. The plain paper releases and absorbs residue from the rollers and separator pad.

If the problem persists, clean the rollers and separator pad manually

Look where you put the paper in. See if you can see inside there and see the roller that turns and picks up the paper. If you can, make a mixture of alcohol and a little dish soap. Damp a rag with it, and reach in there to clean the rollers.  See if the rollers will turn manually, but be careful not to force anything.  Another way to get to the whole roller, would be to start making a print, while watching the rollers.  As soon as the rollers have turned half way, unplug the printer.  Now you can reach the other side and clean that.

There is another way to clean the rollers.  Using the alcohol mix, take a single sheet of paper, and damp one half of it with the solution.  Stick the single sheet in the paper tray, and make a print, but hold on to the paper so that it doesn't feed through the machine.  Do this several times, and the rollers turning against the wet paper should clean them.

Try to print again. It might take a few tries. The rollers have to turn against the paper and dry themselves off again.
If this works, then you need new rollers (cleaning them will only make them work temporarily and the problem will come more frequently until you change them).

Thankyou,

sell on ebay?