- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This needs a special remote to get to the factory alignment screen.This is the part # for the remote ---#105-201m .
You really should call a good TV Tech on this one. They are a convergence nightmare for even a good Tech.
That would be the convcergence ICs and feed resistors that need replacement. Can you reply to this same post and verify that your model is the R56W36? I will then post the correct ICs and feed resistors for your model as well as a link where you can get replacement ICs and resistors with free instalation instructions with pictures.
If you replaced the convergence ICs did you check the convergence resistors as well, as often the old ICs will take out a few resistors in the Convergence feed circuits or at least increase their values and that can give those symptoms youre describing after new ICs are instaleed.
Hi, you can order it here www.partstore.com or 1-866-925-7278 be prepared they are not cheap, if you do this yourself make SURE you mark ALL of your plugs as you pull them from the old board if you put a plug in the wrong place you can destroy the new board and they will NOT take it back once you purchase it, good luck , BMW Rider