I have the a pak delux 10-0623. I am nit sure what this even does! But this morning it started buzzing and now the light stays lit on top of the unit. What does this mean, what do I need to do, what does this unit do? The unit is mounted on an external wall of my house and is 1 year old. Thanks for your help Peter Redmond

Sounds like a short in the plug where the top bulb went.

You were FORMATTING it? Meaning... you were erasing the operating system? If that's the case, then... you have no operating system and the computer cannot boot up because it has no operating system to boot into.

Good Morning Kim,

I see that the heavy light is staying lit on your Electrolux dishwasher, model# EIDW6105GS1QA, even after resetting your appliance at the circuit breaker. I also see that there are no lights lit up behind the kickboard, indicating what might be failing. It could possibly be the control board underneath your dishwasher. I suggest contacting your local authorized technician for further assistance. They will be able to diagnose your appliance and determine what is causing the heavy light to stay lit. I hope this is helpful.

-Best Regards-
WP

Hi have you checked the brake fluid level ?

this would be a bad power pak or bad power supply inside check the power pack first, if this does not have a power pak the nit would be internal thanks

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

The 'thermocouple' might not be working. Is the pilot light staying lit? The therm. sends a millivolt signal to the control insuring a pilot is lit.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

The thermocouple is bad. That is the part right next to the pilot light that sense's the flame and hold the gas valve open to the pilot. Take the old thermocouple off and go to hard ware store and get a 18" one of what ever length you need and replace. 5 dollar part.

Hi There,
I just wrote and now that I got your second message this is exactly how the faulty coil pak acts.
The car will get you from point A to point B but when you get back in the car and try to start it, it just cranks over. But wait awhile and it will start again! For $50.00 try a new coil pak, chances are this just might solve the problem. And by the way, your check engine light is not connected to the coil pak, that is usually an emissions problem and you can deal with that later. Please let me know if this helps you and thank you for using FixYa!

If your husband plugged it in without turning it off, the jumper pak, or the control deck itself is more than likely fried. Check and see if the control deck will work with the memory pak, instead of the jumper pak inside it. If not, the control deck is fried, and you'll need to buy another N64.

thats not a valid model number open the fridge door and look up at the top by the light bulb on a white sticker and ill try to help ok