My screen is stuck on a location i am not at- it is basically frozen and does not tack my movement. and will not update- i let the battery run down and tried resetting factory settings what can i do to make the gps locate me

Try hard reset?
http://www.youtube.com/watch?v=A0QTdNFkcd8

This message means that there is a button that is stuck down on the remote. All you need to do is un stick it!

1. Take out the battery
2. push in and massage each button to ensure it is not stuck down.
3. Put the battery back in, update the firmware.
4. Update the remote.


Hope that helps you out

Remove the batteries from the remote. Push in, and massage each button ensuring it is not stuck down. Replace the batteries and Update the firmware. Update the configuration. Did this fix the problem? If no, please e-mail us back for further information about your issue.

Firmware and Configuration Steps:
1. Log into the Logitech Harmony Remote Software on your computer
2. Click on the Downloads button at the top-right corner of your screen
3. Click on the Firmware button. Follow the onscreen instructions to upgrade the firmware on your Harmony remote
4. Once the firmware upgrade is complete, click on the Update Remote button
5. Test your remote.

Hi there,

According to your issue the windows logon screen gets stuck on update 3 of 3 it seems to me you were trying to perform windows update and now the updates are not installed properly in your system due to which you system stuck in such kind of cases you have to perform system restore to uninstall the updates and for that we need windows vista basic dvd in order to get the steps to perform system restore follow the link bellow :

http://vistahomebasic.windowsreinstall.com/repairsystemrestore/repairsystemrestore.htm

Regards,

Om

Big problem .. you had a bad firmware download and the unit is now stuck in the development mode. Two solutions .. 1) return to Magellan for a replacement. 2) If not in warranty .. there is a third party repair center on the internet .. use your browser and search for 'magellan triton repair'

JG

Press the reset button - you'll find it on the lower right of the Nüvi 255, but it doesn't look like a button. It's basically the sticker with all the information on it. It's just enough to push the sticker carefully with something small, not too sharp so it doesn' get destroyed. The Nüvi reboots, the loader loads and proceeds with the software load. Once this is over, shut down the Nüvi and reconnect to the PC. Then, everything works fine (it did at least for me).

just simply tack out the battery to turn it off

It seems as thought the player itself has actually frozen. I have the same player and it has never done this to me. If you havent allready try leaving it alone in a quiet place for a day or two until it runs out of battery. Then plug it in to your PC to charge and it should be okay. As this has happend to me with other players. If it isnt however, try to resolve the issue by somehow updating the firmware. Try googling "SanDisk Sansa e260 Firmware Upgrade" and see what you can find. If there is something which looks hopeful try it, but if it doesnt work, the perhaps the only option is to return or exchange the player at its place of purchase. P.S Check the USB modes.

ow!!! you got a virus! a doomboot virus and or flakes virus! do not open again your mp3! you have to remove your virus with twister series!

check battery, run without the battery, using ac adapter, see if problem persists did you update psp firmware? if so, undo the update, go back to previous firmware version