I need a code to restart my JVC car radio/cd player. I disconnected the battery and now it does not work. The model N° is KD-LX10RE & the serial N° is JV2010M2A72520. Thanks for assistance.

try their website

as far as i know there is not code for this radio.

as far as i know jvc has never used codes. try pressing the reset switch (would be a pencil tip size hole on either the face or the subpanel, if it has one) or disconnecting power to the radio for a few minutes.

try pacparts.com

no security code on this radio. try to unplug the power harness to reset the radio. that should take care of the problem

Do not cut the wires from the car. Instead, call Crutchfield at 888-955-6000 and order the adapter part number 120701003. When you call them, ask for color coding. For JVC, refer to the attached picture. Match the adapter color code with that of JVC. If the adapter color code is the same, then connect ground (black), battery (yellow), and wire from ignition switch (red) securely. Turn on the car and see the radio works. If it works, connect one by one speakers and confirm. Remember, perfect connection gives reliable installation.

I had the same problem, the cd refused and radio plays good, with JVC KD G321. I have disconnected the switches behind the radio and also disconnected the antenne (do not forget the antenne) and it played the cd again.

Jan (my english is not so good, i hope my solution is better.

if you have a wiring harness al the wires are color coded to match the after market radios colors. the yellow constant wire goes to 12 volt or battery wire. the accessory wire would be the red wire that is the switched 12 volts. the remote is for the factory amp or an aftermarket amp which turns on and off it would be the blue with white wire.

need code
JVC CAR RADIO MODEL KD-LX110R

serial no. 17600125

the code for this radio was not set by the factory, but by the original owner and the code could be anything-unfortunately unless you contact the original owner and they know the code you are out of luck