Question about RCA Projection Televisions

1 Answer

The tv won't turn on! It clicks at times like it normally did but the power goes off within a few seconds. There is no picture or sound at any time. I checked all the connections, changed the batteries in the remote, plugged the tv into a different plug with a different electrical circuit and read the trouble shooting section in the manual but None of these turned the tv on! Our tv is an rca January 2003, model no. F36650, serial no. D023C21AJ. Hope you can help Frank Lodewyks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Good Afternoon FixYa
Unfortunately my problem is not fix and unless you could give me simple solution I can't fix it anyway. I am surprised about RCA cost to getting and answer. All I really wanted to know is if I had to take it to a repair shop or not?
Anyway, thanks for your reply
sincerely Frank

Posted on Jul 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 65 inch projection TV turns off within a few seconds when I turn it on. Why? No pictures or sound.


If power light does come on and a few seconds later it goes off---do the self check that the WS65909 MITSUBISHI should have:

On the front of the set press and hold both the MENU and INPUT(OR DEVICE) BOTH FOR 5 SECONDS AND THEN RELEASE BOTH BUTTONS.

Power light should blink a two digit code--error code---for example: 2 blinks, a pause and 2 blinks.

Let me know what code you get----it will repeat it several times---and I will tell you what it means.


SD TECH

Nov 03, 2009 | Mitsubishi WS-65909 65" Rear Projection...

1 Answer

Tv turns on w/pic then pic dissapears light blinks 4 times


I have the same issue, we've had to change our bulb three times in less than two years. now we have 61" expensive paper weight. Our current bulb is less than 6 months old. The TV is only 2 years old and like i said this is our third bulb.

the blue light blinks 4 times. you get sound. then a few minutes the the picture returns... then it goes out, and the cycle goes on.

A solution to this would be greatly appreciated.

Oct 08, 2009 | RCA HD61LPW165 61" Projection HDTV

1 Answer

Turn on the TV and only Timer light is on , no sound & picture


after holding down the menu and device the led will blink a two digit error code such as 3 blinks pause then 4 blinks then repeat that sequence a couple of times. Need that blink code to help let you know whats going on. The 34 code means lamp abnormality which translates to the power Pwb capacitors have most likely failed.

Jan 23, 2009 | Mitsubishi WD-52525 52" Rear Projection...

1 Answer

Sony KF-60WE610 Screen and Sound On/Off


All symptoms in your TV shows that you need to replace its Lamp as it has been consumed its life hours and TV requires new lamp. Lamp can be obtained from Sony Website. Price is $200, Hope this info will help you to enjoy your Sony TV in coming days.

Aug 17, 2008 | Sony Grand WEGA KF60WE610 60" Rear...

1 Answer

No Picture


Can you tell me how many times the light flashes before it goes off? Please reply to this same post and I will try to assist you.

Aug 09, 2008 | RCA HD50LPW175 50" HDTV

1 Answer

TV turns itself off after a few seconds, no picture at all


I had a similar problem with my Phillips 42 in. LCD HD TV.

Here's the problem. The Power Supply Board. I opened my TV up(warranty was up of course) and found several bad capacitors. Phillips and several other companies were sold capacitors that although were highly rated failed within 5 years because of a lack of preservatives. All sorts of electronic equipment is now being effected due to these defective capacitors.
Solutions?
1. Take it in and have it fixed
2. Open it up, check the board for faulty capacitors(bulged or leaking) Buy a new Power supply board and install it.
3. Remove PSB, remove faulty capacitors and replace with compatible new ones.

Hope this helps

Mar 28, 2008 | Samsung HLP4663W 46" Rear Projection HDTV

1 Answer

Sony 57 inch WEGA Projection TV


Hi, this is a very common failure, you need to replace 2 IC chips on your power supply board, marked on the top of the IC`s is this number: MCZ3001D you can purchase them here if you are very proficient at soldering & un-soldering, and the board has to come out of the tv to do this, you might want to call a tv man for this one, but it will fix your set, happy holidays, BMW Rider

Nov 29, 2007 | Sony Grand WEGA KDP-57XBR2 57" Rear...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Are you a RCA Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...