I got to much red in the backgound how do you fixed it

i can't see jellies in candy crush game due to black background

Hi,

Try this if you have Windows 7 loaded.

1. right click on the desktop backgound.
2. select "screen resolution" from popup menu.
3. under the "orientation" drop down select "landscape"
4. click apply then ok.

Does this fix it?

:)BD

This sounds like the alignment of the red beam is off. There is usually a configuration tool in the menu that shows a white cross in the center of your TV against a black backgound (if it's aligned properly). It's a combination of the red, blue and green light bars hitting the screen. You should be able to adjust the positions of these crosshairs for each of the colors and "fine tune" your picture. Some of the higher end TV's even do a grid with over 100 crosshairs to fine tune every few inches or so. Once you get the red beam in line with the others and save the settings you should be good to go!

This is the begining of a video problem. You will soon see a E74 ERROR soon with one red light in the lower right. Any fix for this will be temporary. Some time it can be fixed with the X-Clamp fix. How to do it is all over the net.

Out of Warranty pal. You can attempt to fix it yourself, but, if you don't have an electronics backgound, I don't expect you to succeed. Best replace it.

I suspect a connection problem i.e either at the plug and or pcb behind the screens cover/panel or where it connects at the body of the Laptop, (again under a panel/cover).

Get yourself a Service Manual to see how and where the connectors are just incase you have no idea where the screws are to remove and inspect.

I suggest the above as I recently fixed an IBM laptop with almost ientical problem.

Hope the above is of some help.

same problem on mine, its a known fault on panasonics website and requires a software update

earth loops !! try a 1:1 audio transformer ( ground-loop isolator) available in car audio shops
cost estimated.$10-15.

Your green CRT may be going bad, You can get a replacement CRT ( picture Tube) at the following link very cheaply with free instalation instructions.
http://servicemanuals.vstore.ca/

This sounds like it might be a defective CCD imager. If so, Canon should fix this for you for free, including free shipping both ways. This is regardless of your cameras warranty status. Please check the following two links for more info:
http://camerarepair.blogspot.com/2007/11/canon-digital-cameras-showing-black.html
http://www.usa.canon.com/consumer/controller?act=PgComSmModDisplayAct&fcategoryid=225&modelid=13390&keycode=2112&id=29819
Applicable cameras include:
A40, A60, A70, A75, A80, A85, A95, A300, A310, S1 IS, S60, S200, S230, S330, S400, S410, S500, SD100, SD110
By the way, here's the info for India:
http://www.canon-asia.com/index.jsp?fuseaction=support&prod_type=image-phenomena_notice
http://www.canon-asia.com/index.jsp?fuseaction=contactus&prod_type=sales_service_in