My mouse is working backwards. What do I need to do?

You probably need to clean the mouse wheel. If this doesn't work it probably means there is a bad connection inside and you need to replace your mouse.

If the Transceiver that you plug into the USB port is not functional, the mouse is not working either. Check your mouse batteries for power and also polarity, they may in backwards.

go into setings and there will being a setting that says vertical change it to horozontal sorry about my spelling

If you installed the battery backwards it will not work. Look in battery compartment for battery symbol showing which way the tip should go, or a "+" symbol. There is a transmit reset button on the mouse to hold down for the computer to recognize it. What is the problem with your printers?

Hello, Allow me to try to figure this out here.

Your saying batteries and mouse so may i assume this is a wireless mouse for a moment?

Okay once you replace the batteries in the mouse you need to unplug the little transmitter from the computer, Reboot, Then plug it back in.

This would allow it to re-sync being that its infra red or otherwise.

So try that. Take out the little transmitter thob, reboot, plug it back in, the mouse should be working again.

1.Check the batteries are they in backwards?
2.Check the battery connectors inside,

Now if this is a IMAC or something like that quickly let me know!

Thanks for using fixya.com I hope this was very helpful.

Regards


Rulds2008

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

With proper drivers and if it was working with other Windows XP/VIsta, it should work as win 7 is backwards compatible.

The Micro Innovations infrared mouse kb985w is a Plug-n-Play device and does not require any additional driver.

Windows 7 USB ports are backwards compatible with USB 1.1. Your mouse should work with Win 7 with any driver installation.

But if you're asking for driver to reprogram the buttons of your mouse, you need to contact the manufacturer and verify with them if they have a software that would work with Win 7.

Good luck and have a good evening!

usually on the bottom of the mouse is a small slide type door with a small indent
slide it open and change batteries, if for any reason mouse were not to work still, look for the reset bottom on bottom of mouse and press it and you might even have to hit reset button of the eye also.
I mention this because of batteries if they are all the way dead sometimes you will have to reset.
keyboard is the same way

Go to control panel, mouse, buttons tab, uncheck "switch primary and seconday button"...

Pls rate this solution.

THE POWER SOURCE IS GETTING LOW AND IT IS TIME TO CHANGE THE BATTERIES

ROD