Question about Razor Dirt Quad Bike

2 Answers

Not responing to the trottle. - Razor Dirt Quad Bike

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

The Main controllers always seem to be the problem on these quads. If you have a voltmeter you must check the batteries for a complete charge. You should read 24volt or around 24.60 vdc. If you have a full charge usaully 12-16 hrs by the charger supplied with the quad. Than check the output to the motor by disconnecting the motor wire and put your leads in the sockets and verify if you are getting voltage to the motor. Make sure you re-connected the battery before testing the controller output. You should see a varying voltage from 0-24 vdc when the throttle is turned. If you do not see anything at the motor lead and your batteries show charge. the controller is faulty or you have a bad connection. Un-plug and plug and connectors.

Posted on Jan 17, 2011

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

What is the problem when my son 48lbs. twist's the throttle and we hear a whinning/grinding sound and the quad doesn't move. If i lift the back tires off the ground the wheeles will turn but we still hear the same sound. the quad is like new and is kept indoors when not in use. Any thoughts or soultions????

Posted on Apr 10, 2011

  • mikejenn3 Jul 25, 2011

    this is what happened to my sons...same situation, kept in a garage when not using, fully charged, back wheels moving, brand new machine maybe 5 months old...what was the solution? Were you able to get it fixed?

  • Steve
    Steve Apr 05, 2014

    Just purchased one, used it for 3 days, fully charged today and same problem. If I lift back wheels off the ground acceleration is fine, when he sits on it it sounds like a grind, he only ways 40lbs

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am having a problem with the trottle . when i cirst start the tractor i can trottle the engine up and down,


You may have a fuel restriction. If it has a fuel filter remove it and blow through it. If there is any more than slight resistance, replace the filter and try again.

Nov 04, 2015 | Garden

1 Answer

Low rpm at idle but boggs when you step on gas pedal


Hi Alex possibly a dirty trottle body. Get a can of trottle body cteaner and start car. Then get someone to revv it up over half way and spray cleaner in bursts of 3-4 seconds into the trottle intake. Regards Jim...

May 20, 2015 | 1997 Toyota Camry

1 Answer

I own a 98 chevrolet malibu an engine code came on PO122 trottle position sensor how can a get fix


trottle position sensor is on the trottle body opposite the throttle cable

Sep 14, 2011 | 1997 Ford F350 Crew Cab

1 Answer

How to adjust idle on 94 eclipse


you should be able to adjust it by the trottle cable check under the hood and see if theres not two nuts holding your trottle cable in place if so ajust if need be. this is a easier way to increase your rpm at idle but you shouldnt be able to decre your rpms at idle this way. for that yu may have to look and see if there is a adjustment screw on your trottlebody that can increase and decrease your rpm at idle. if your have a low idle problem try cleaning the inside of your trottle body really good with a lint free rag and some trottle body cleaner also try cleaning your idle control vavle if cleaning your trottlebody didnt help.

Jan 22, 2010 | 1994 Mitsubishi Eclipse

1 Answer

Trottle body gets black have changed Oil etc he


How do the breather valves look on top of the valve cover?

Oct 28, 2009 | 1994 Jeep Grand Cherokee

1 Answer

VW PASSAT 1.6 PETROL. Engine cuts out everytime slow down, otherwise it's fine. I've had the trottle box cleaned and new air pipe fitted buy problem persists. Could it be the Brain (ECU)?


hallo
remove, clean trottle body. use trottle body cleaner(spray) or nitro and some small brush)It should shine from inside, allso/especialy below the flap (hatch). if you have possibiliti do basic setting (tester).
it is not ECU faulty
marko

Oct 06, 2009 | 1999 Volkswagen Passat

2 Answers

Need to know what the throttle body looks like & how to replace it..


The trottle body is located on the intake manifold. There will be a black tube going to it. This tube is the breather tube and on the opposite end is the air filter and it container. You trottle cable and cruise control cable will also be attached to it. If you are unsure of its location, have a friend get inside the car and work the gas peddle. While you are looking at the top of the moter, you should see the linkage at the trottle body moving. Tha linkage is part of the trottle body.

Sep 16, 2009 | 1996 Mazda Protege

1 Answer

2001 ford taurus will not idle down


several things can do this but most likely would be
1 TPS trottle postion sensor = replace
2 stuck butterfly valve inside the trottle body = clean out with trottle body cleaner try to get most of the black build up with a old tooth brush
3 bad trottle cable= feel the cable make sure it moves freely if not replace it

Feb 20, 2009 | 2000 Ford Focus

1 Answer

My ps2 slim wont recognize any disks


1 ) First did u try other disk beside that one if yes and same no respone

2 ) Then try using disk cleaner with anti static liquid

3 ) Let it run about 10 minite

4 ) Try the disk games if no respone

5 ) Open your ps2 and make some cleaning but do not ever touch the lens

6 ) After that try back the games if not respone try

7 ) Listen to the disk spining or not if no mean the spinner broken or part in ps2 mean cost a money if yes i think your lens must be replace

Dec 01, 2008 | Sony PlayStation 2 Slimline Console

Not finding what you are looking for?
Razor Dirt Quad Bike Logo

2,135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Razor Rock & Ice Climbing Experts

kakima

Level 3 Expert

102366 Answers

RatanbssBD

Level 1 Expert

6 Answers

Bill Boyd

Level 3 Expert

42159 Answers

Are you a Razor Rock and Ice Climbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...