Question about Garmin Nuvi 610 GPS Receiver

1 Answer

I do not always get a signel - Garmin Nuvi 610 GPS Receiver

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 96 Answers

This is a problem in many navigation system. Place yourself where you get signal. insert your route, write it down in a piece of paper this way you will have it handy for when you loose signal.
Tom Tom is my favorite system and the signal is very good in it.

Posted on Jul 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have navman tracker 5500 gps and the gps signal not working so there is no signel but all the charter is there


I HAVE THE SAME PROBLEM.U WILL FIND THE ANTENNA IS BUGGERED.THERE ARE NO SPARE PARTS AVAILABLE FOR THIS MODEL.LESSON; DON'T BUY NAVMAN OR NORTHSTAR.I HAVE ONE OF EACH. NEVER AGAIN!!!

Nov 17, 2009 | Navman Tracker 5500i GPS Receiver

1 Answer

My gps saids i am always in new york even though iam in maryland never moves from new york


If it is constantly on a singloe map location and never cuts in to navigate thjen suspect that
1) the antenna is afunctional, disconnected, or not working to lock onto satellites.

2) The chip that locates and communicates with the satellites is dead.

If it always shows a particular location when started, but does navigate to where you ask it to take you, but always returns to the base location when tuened off and then on. The program in your home address or in SETUP program your location and time zone to have it always start in Maryland.

Jun 07, 2009 | Pioneer AVIC-N3 GPS Receiver

1 Answer

No satdallights signal


When changing out the battery, you may have pinched one of the wires on the antenna board or it's not mounted correctly.

646e4d4.jpg
Try taking it apart again and checking the wires. There are only two of them on the antenna part.

Apr 08, 2009 | Garmin StreetPilot C330 GPS Receiver

1 Answer

Garmin Nuvi Firmaware Update Complete, Unable to catch satellite signal


Try performing a reset of the unit. Hold down the bottom right of the touchscreen and turn the unit on. It will ask you whether you want to reset allk data. Choose yes and try again. This should solve your problem. Hope this helps.

Feb 20, 2009 | Garmin Nuvi 660 GPS Receiver

1 Answer

No gps signel on my evesham navcam 7000


Evesham is no longer in business but the following url is for a company that supports their products..
http://www.tewktech.com/

As a matter of fact, I understand this company has ex-Evesham employees. Good Luck and please rate this solution ....

Jan 10, 2009 | Evesham Nav-Cam 7700 GPS Receiver

2 Answers

Tomtom not finding gps satellites


i had exactly the same problem, i dont really know how i solved it but first i thought it could be a memory problem slowing the gps signel so i reset the tom tom to factory settings then downloaded the updates from the tom tom home program of corce i lost all my destinations but i didnt want to do a back up just incase one of the updates had a virus or something so if u want to keep them i sugest u write them down first.and then i got a safty pin and pressed the reset button underneath where the memory card goes twice the second time i held it down for about 10 seconds then i looked for updates again from tom tom home. after that in tom tom home there is an option where u can operate your tom tom on your pc so i tryed that and i put in a destination on the pc and clicked on demo tour so i watched the route first it was a bit slow but started to speed up a little. after it had finished i un plugged the sat nav and went for a walk with it around the house soon as i went out side and set a destination it found 6 gps signels,make sure yhe battery is charged to at least half. well i hope anyone who follows my steps gets the same results, thought i lost 200 quid cos i have had it over two years and its only guarenteed for 12 months. well good luck.

Jan 07, 2009 | Tomtom One XL GPS Receiver

1 Answer

Always have to reset clock


Have you gone to the TomTom site to see if there are any new upgrades. There may have been a miss program in that model that may need to be upgraded.. I use a tomtom and have not had any trouble.

Jun 06, 2008 | Tomtom GO 910 GPS Receiver

2 Answers

Charged my new nuvi 760. Unit will not turn on. Followed the steps in manual, held the on button to the left for 8 seconds, then turned it on and nothing. If I plug it back into the wall charger the Garmin...


To power the unit back on, press the "Mode" and "Reset" buttons at the same time. Let go of those two buttons, press the power button, and the unit will turn back on."

Apr 28, 2008 | Garmin Forerunner 305 GPS Receiver

Not finding what you are looking for?
Garmin Nuvi 610 GPS Receiver Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garmin GPS Devices Experts

Tom Chichester

Level 3 Expert

24685 Answers

Jonathon summesfield

Level 2 Expert

284 Answers

Bill Gilhooly
Bill Gilhooly

Level 2 Expert

94 Answers

Are you a Garmin GPS Device Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...