Question about RCA Projection Televisions

1 Answer

The tv when you turn it on a blue line comes on in tme middle and then another blue line comes on and the tv goes off

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • RCA Master
  • 8,617 Answers

Youre having vertical deflection problems thats what is shutting down your set when the blue line comes up. What is the model number of your RCA and i will be able to help you out. Please respond to this same post when replying

Posted on Jul 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1. My Sony KP-57WS500 TV is turning blue after abut 3 minutesof operation. It stays that way for about 30 miunes and comes back with pictures again, but with predominatly blue color. 2. Sometimes the TV...


Sounds like the picture tubes are failing,common on sony. do you notice any thin horizontal lines? You mite get lucky and be able to adjust the voltages. Remove back cover and look inside to see which tubes are lighting up.The front panel below the screen will come off and behind it is a small access cover.remove it. there you will find the voltage controls (its a plastic square with 6 knobs). 2 knobs for each tube, 1 is focus the other is the voltage labeled "screen". they are marked so look closely. Green is always in the middle but sometimes they flip the controls for red and blue so pay attention to which you are controlling .slowly adjust screen voltages to see if you can get it to stay on. If you over do it those thin horizontal lines will pop up and the tv will shut off again. If you already have lines back off the voltage by turning knob to the left slowly until they diappear. If that seems to fix it but the problem but it comes back later, then the tubes are shot. good luck!

Jul 05, 2010 | Sony KP-57WS500 57" Rear Projection...

1 Answer

Rca D52W20 blue screen when turned on


Almost certainly the blue picture tube is bad. This is a huge job to replace and quite expensive. Generally it is not worth doing.

Mar 26, 2009 | RCA D52W20 52" Rear Projection HDTV-Ready...

1 Answer

Weird blue flash when tv turns on or off


TV will need service soon, blue CRT is on its way out, will need replacing

Mar 25, 2009 | Sony KP-51HW40 51" Rear Projection...

1 Answer

Tv comes on for a few minutes then goes off


If you take off the front bottom panel of the tv wich is easy. Then you will see 6 tuning knobs at the bottom middle of the tv .the top 6 control contrast for the lights dont mess with those. the bottom 3 are the power to each light.red is bottom left if your screen went blue it makes sense that the red is starting to go but if you turn down the power to it left 1/8 turn it should fix it for awhile .Its easy.

Jan 01, 2009 | Sony KP-57WS500 57" Rear Projection...

1 Answer

Old Projection telvision on the fritz


you need to change the CONVERGENCE ICs , if you cant do it then it needs to be serviced by a HITACHI authorize service shop , hope this helps AJ

May 27, 2008 | Hitachi 51SWX20B 51" Rear Projection...

2 Answers

Curved blue lines on screen.


You have a completely different problem. The screen voltage for the blue picture tube is slightly too high on your set. This will put fine lines in the background of the picture, called retrace lines. This is very common and easy to correct. Remove the front speaker cover and the access panel behind it. Look inside and you will see a black box with six controls, each control having a little white glue on it. This is the Focus/Screen block. Three controls are labeled Focus and three are labeled Screen. The screen control in the center is for green but I am not sure if the screen control on the left or right is for blue for your model. With the TV on, set it to VIDEO 1 but do not connect anything to the VIDEO 1 jacks. This will produce a pure dark picture, showing any faint lines in the background. Choose one of the screen controls and increase (turn clockwise) it slightly. If the blue lines do not get brighter it means you are turning the red screen control, so put it back where it was and choose the other screen control. When you find the blue screen control, decrease (turn counter-clockwise) it until just when the blue lines are gone. If you want you can check that the red and green screen controls are set to just below the point where their faint lines are visible. When done, replace the panels and your picture will be back to perfect.

Apr 11, 2008 | Sony KP-46WT510 46" Rear Projection HDTV

1 Answer

My Hitachi 65SWX20B Model, made in 02, just developed Picture disturbance


Can you post a picture of the set. This might be a convergence problem. seeing the set will confirm this.

Thank you,
shuttle83

Oct 28, 2007 | Hitachi 65S500 65" HDTV-Ready Rear...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Are you a RCA Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...