The spin cycle is not realising the waste water out of the machine

I think the water is syphoning back from your waste outlet make sure the waste pipe is installed correctly

It sounds as though you either have a clog in the drainage system of the machine, or a bad drain pump.

YES..I think drain hose @ sink too low Waste water from sink entering machine...Raise pipe....tie up ....

Check pump and filter if there is one Take waste hose out a little and see if water is being discharged on spin cycle hope this helps?

I do not have the exactamundo but here is an GWlo3 Repair Manual with photos F&P Fileshare

Bonus


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

sounds like your water pump is not pumping waste water out, it maybe blocked, have you tried cleaning the filter.

when on spin check to see if you can hear a low whirring noise {the pump} if the machine is not pumping or not pumping fast enough for sufficient water to drain out of the machine then the machine will not spin due to having to much water in. i would also check to see if all filters on the waste water output are clear of any foreign bodies as this will reduce the speed of which the water is pumped out of the machine{some machines have 2 filters } good luck

Hi Richie. Your machine (in fact any machine) won't spin if theres water inside the drum (the pressure switch makes it impossible). Sounds like you have a blockage on the waste pump. If there's a filter at the fron, get as much water as possible out the machine, get a few towels and then open the filter. If there's no filter, pull the machine out, tilt it on its back a look for the waste pump (the part that links to the waste hose). Clear any blockage.
If after you removed stuff out of the waste pump, if it still not spinning, then it will be the motor brushes. Remove one and check for wear (if its below 1cm then they need changing, they are normally 5 to 6 cm long).
Cheers

Behind the little door is the filter which will be full of this stuff.
Just unscrew and take it out to clean.
Thankyou for using Fixya.

These problems can be tricky to the novice, what you have to keep in mind is that if one of the sensor flags an error the whole washing cycle will stop

In your case I would make sure that the waste water output is completely clear of buttons,hairs and toys.

You should also check the filter section (if available) on the waste water output, this catches any coins