Question about Dishwashers

1 Answer

Remove pump - Dishwashers

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 95 Answers

Will have to disconnect power, and remove whole washer. When the washer is removed and set on it's back, you can remove the pump and housing much easier

Posted on Jul 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I clean pump in my dish washer


First, are you sure the pump needs cleaned? If it is not removing the water from the machine it could be a couple of reasons. 1. The timer (electronic board) could be bad and not sending a signal for the pump selenoid to open an allow water into pump for removal. 2. The drain hose from the DW to the house drain could be plugged up. But to answer your question. First remove all elecric power from the machine. 2. remove the kick plate on the bottom. 3 you will see the motor and pump in the center. (each model is different) but you may need to remove the motor and pump as one unit from the DW. or you may be able to access the pump housing with out removing from machine (usually there are small clips that hold the housing(cover) on the pump. Get them off and you will have access to the impeller.

Dec 12, 2014 | Dishwashers

1 Answer

It will not drain water


Hello there:
Please read the solution that i have provided for you CAREFULLY THERE IS A LOT OF INFORMATION IN HERE

t won't drain If your washer won't drain, check these: It spins, but doesn't pump It doesn't spin or pump It pumps, but the water returns It spins, but doesn't pump If your washer spins but doesn't pump the water out, the drain line is probably clogged. In many washers, a small sock or other piece of clothing can get between the clothes tub and the outer tub that holds the water. If the clothing gets between the tubs, it may then get into the drain hose that's attached to the pump--or even into the pump itself. If it's in the pump, you need to remove the hoses from the pump and pull the item out. To remove the sock from the outer tub port, open the washer's main access panel and remove the large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then, using needle-nose pliers, try to grab and remove the clothing through the port. Sometimes you can't remove the stuck clothing from below. Then you have to remove the agitator, top of the outer drum shield, and inner clothes tub. This isn't easy to do--and you may need special tools--so you might be happier getting a qualified appliance repair technician to do the job. If the drain line isn't plugged, the problem may be with your pump. Even if the pump appears to be turning, the internal impeller may be broken. If so, you need to replace the pump. It doesn't spin or pump If your washer doesn't spin or pump water out but the motor is running, your washer probably has a frozen pump pulley. If so, you need to replace the pump. To check the pulley, remove the pump from the washer and try to rotate the pulley manually. If it doesn't turn freely--if it's frozen or stiff--replace it.

Jun 05, 2010 | Maytag Dishwasher

1 Answer

Access to Dishwasher Pump to check for Blockage


Turn off the power to the DW.
Remove the screws holding the door panel on(not the control panel screws).
Remove the "toekick" panel from the bottom of the DW. The pump will be in front of you.
Use a volt meter to check for power to the pump. If there is power,remove the pump and check for a blockage. If no blockage you can make a 120 volt test cord to power the pump to see if it works.

Jan 06, 2010 | KitchenAid 24 in. KUDS01FLBL Built-in...

1 Answer

Kenmore dishwasher stock #16469 (Part #665.16469300) motor/pump made loud steady noise then stopped working. How do I remove motor/pump?


remove the D/W from power
remove the front bottom grille
reaching under the machine with a flashlight ;you will see a black rubber plug held on the pump bottom by a spring clamp remove the clamp with a spring clamp plier put your index finger in the pump and, carefully attempt to turn the pump impeller until it spins (the debris that was holding it will fall out
put everything back and, repower the machine

Aug 30, 2009 | Kenmore 24 in. 16462 / 16464 / 16469...

1 Answer

Washer will not drain after wash cycles


If your washer won't drain, check these:

It spins, but doesn't pump
It doesn't spin or pump
It pumps, but the water returns
It spins, but doesn't pump If your washer spins but doesn't pump the water out, the drain line is probably clogged. In many washers, a small sock or other piece of clothing can get between the clothes tub and the outer tub that holds the water. If the clothing gets between the tubs, it may then get into the drain hose that's attached to the pump--or even into the pump itself. If it's in the pump, you need to remove the hoses from the pump and pull the item out.

To remove the sock from the outer tub port, open the washer's main access panel and remove the large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then, using needle-nose pliers, try to grab and remove the clothing through the port.

Sometimes you can't remove the stuck clothing from below. Then you have to remove the agitator, top of the outer drum shield, and inner clothes tub. This isn't easy to do--and you may need special tools--so you might be happier getting a qualified appliance repair technician to do the job.

If the drain line isn't plugged, the problem may be with your pump. Even if the pump appears to be turning, the internal impeller may be broken. If so, you need to replace the pump.

It doesn't spin or pump If your washer doesn't spin or pump water out but the motor is running, your washer probably has a frozen pump pulley. If so, you need to replace the pump. To check the pulley, remove the pump from the washer and try to rotate the pulley manually. If it doesn't turn freely--if it's frozen or stiff--replace it.

Aug 11, 2009 | Dishwashers

1 Answer

How do remove the sprayer arm?


Hi mathenywasja,
   For removal of spray follow :-
http://www.acmehowto.com/howto/appliance/dishwasher/check/sprayarm.php

http://www.partselect.com/repair.aspx?appliance=dishwasher∂=remove-spray-arms



To replace pump, procedure would be :-
The pump is not difficult to remove and replace. If you have a little bit of mechanical ability, you can replace the pump easily. You can find the pump by following the drain line into the bottom of the dishwasher. The drain line connects to the pump.
The pump will come out fairly easily by removing a couple of fasteners. Make sure you find an exact replacement part or you could be in for a world of trouble.

Thanks for using Fixya.


Do rate the solution.

Apr 16, 2009 | Dishwashers

3 Answers

We have a Bosch Model SKT5102GB/07 and the problem is as follows; we load the dirty washing and start the washing process, the machine then goes through the full cycle of wash. Once finished you open the...


If your washer spins but doesn't pump the water out, the drain line is probably clogged. In many washers, a small sock or other piece of clothing can get between the clothes tub and the outer tub that holds the water. If the clothing gets between the tubs, it may then get into the drain hose that's attached to the pump--or even into the pump itself. If it's in the pump, you need to remove the hoses from the pump and pull the item out.

To remove the sock from the outer tub port, open the washer's main access panel and remove the large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then, using needle-nose pliers, try to grab and remove the clothing through the port.

Sometimes you can't remove the stuck clothing from below. Then you have to remove the agitator, top of the outer drum shield, and inner clothes tub. This isn't easy to do--and you may need special tools--so you might be happier getting a qualified appliance repair technician to do the job.

If the drain line isn't plugged, the problem may be with your pump. Even if the pump appears to be turning, the internal impeller may be broken. If so, you need to replace the pump.

Aug 08, 2008 | Bosch Dishwashers

1 Answer

Bosch shu9905


Check the drain pump. First, manually initiate drain by pressing the second and fourth buttons on the keypad at the same time. If it pumps out, disregard the rest. If it doesn't at least hum, check for power at the motor.
Remove lower rack, lower spray arm, and screens in bottom, remove all water inside. Check for debris under pump cover in bottom of sump. The drain pump suction is through the hole on the left.
Behind the toe panel on the left is the drain motor, If no debris was found inside, the drain pump may have failed. Remove outer door panel (you may need to remove the two screws on the sides of the control panel.) Remove the metal panel across the top of the motor area , disconnect hose in front of pump, disconnect wires to pump, press tab at top of pump and rotate clockwise to remove pump. The impeller could be loose on the motor shaft, or the motor windings failed.

Mar 10, 2008 | Bosch 23 in. SHU 8805 Built-in Dishwasher

1 Answer

Bosch classixx dishwasher not draining


try removing pump some models can be serviced fron inside well of machine glass can stop the pump from turning
clean out water and remove filters find a screw in base of well remove and remove pump housing check with torch to see if any obstuctions there if not see if the impellor moves around when turned and make shure that the pump is not worn out

Feb 23, 2008 | Bosch 24 in. SRS43C12 Classixx Slim-Line...

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...