Question about Televison & Video

Open Question

Schematic I need to get a copy of the schematic for an LG RT-28FZ10RX TV. Thanks

Posted by on

4 Suggested Answers

  • 1 Answer

SOURCE: Free TV Schematic

i repair a sony model KV-14RDR2 DEAD set but when i press the channel and volume button the l.e.d will blink please help me with my problem

Posted on Dec 30, 2009

  • 556 Answers

SOURCE: schematic for a sanyo avm 2506 tv

schematic for a sanyo avm 2506 tv. please check www.serviceinfo.com for schematic diagram.

Posted on Sep 28, 2007

ladywinn
  • 5138 Answers

SOURCE: rca 32v434t schematic

www.Service Manuals.net ThankYou for using FixYa. Have a Nice Day.

Posted on Feb 09, 2008

  • 1 Answer

SOURCE: Mitsubishi model No. WS-55807 - In need of schematic please

I have a WS-55807 that will not power up. When the power button is pressed I hear a click from the back of the set, the timer light comes on and 3 seconds later I hear a click from the back of the set, and the timer light goes off. I started checking power to the unit with a voltmeter. For those intersted I have attached scematics: I verified that the PCB main fuse is good and there is 120V at point PT. 9f453c1.jpg
From what I can tell is happening, the power button is pressed and the P-ON transistor is given a signal to conduct which causes K9A50 to close. K9A50 opens after about 3 seconds.

I am looking for other troubleshootinng steps. I have checked fuses F9A01 and F9A06, both are good. What are some other things to check for? Where does the P-ON signal come from?

In the switched supplies regulator circuitry I found fuses F9A04 and F9A05 blown (denoted by red lines thru components). I jumpered around F9A04 and F9A05 with good 5A fuses and the TV powered on. However when the set was plugged into an outlet there was a huge power draw (sparks from the outlet).
1c13374.jpg
After jumpering around the blown fuses, the TV stayed powered on for about 30 sec and then powered down. I pressed the power button a few more times and the same result. The TV stayed on for only 30 sec.

I pulled the middle PCB whichs holds these circuits and I found the
D9A60 diode open and IC8C02, one of the convergence IC's fried. I don't know if these were like this before or after jumpering.

I replaced all bad components and I am back to square one. The K9A50 relay stays closed for 3 sec and the set does not power on any further.
Comment by TV_ITGuy, posted on Dec 19, 2007 Thanks for the advice ctf1800. I have read several posts that speak of the DM unit. I have looked in the back of my set and the DM unit is not in the location shown in the pictures. dcb8806.jpg
As I hope you can see in this picture, there is no DM unit to the far left, just open space. Also the service manual for the V17 chasiss does not speak of a DM module.

I checked the reisitors on the output of IC8C02 which are a couple of 3.9 ohm resistors in parallel. When I test them I get approximately 1.9 ohms, which is what it should be with them being in parallel.

Please let me know if I am off base on any of this. Thanks Comment by TV_ITGuy, posted on Dec 19, 2007 Also, I have replaced both of the Convergence IC's when I replaced the fuses and diode. postsolution.gif Post Solution
addwq.gif Work Queue -->sameproblem.gif Have the same problem? --> Have the same problem? Click Here
X This Problem has been added to the Share Your Expertise Page under "My Work Queue". OK Best Solution posted on Dec 19, 2007 2%20stars.png
c48ee42.jpg
ctf1800
Rank:wizard_s.gif Wiz
Rating: 84%, 2716 votes
first off you should replace both convergance IC and check the resisters coming off the output if any of the resisters are bad it will trash the ic on trying to power up.
i would also replace the caps in the DM section
http://www.jeremyburns.com/Mitsubishi-Green-Blinking-Light-Fix.pdf

http://chrisandnat.com/projects/blinkingtv/blink.htm

Comment by ctf1800, posted on Dec 20, 2007 there are six fusible return resistors ranging from 1.5, 1.8, 2.2, 2.7, 3.3, 3.9 Ohms. I would lift one side of the resister out.
check for any caps that look puffy and check the horz. out put transistor.
Rating Locked! (?) TV_ITGuy has rated this solution as Thanks for Trying

Hope this helps fortuna55@aol.com

Posted on May 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wx416is. Where can I get a schematic diagram and instructions?


Search Results

    TV : Service Manual free download,schematics,datasheets ...

    www.eserviceinfo.com > Electronics > Consumer electronics > TV
    Electronics service manual exchange : schematics,datasheets,diagrams,repairs ...TV - Conventional CRT, LCD Projectors, TFT, Plasma, Big Screen, HDTV, ...

    TV LG : Service Manual free download,schematics ...

    www.eserviceinfo.com > Electronics > Consumer electronics > TV
    TV - Conventional CRT, LCD Projectors, TFT, Plasma, Big Screen, HDTV, Home theater - Service .... dmLG_TIVICT29Q10ET_.gif · Service manual, schematic diagram and parts list ... Lafinion 82W.part1.rar · would like to get a service manual images for (CRT) Tv Where can I get a schematic

Dec 21, 2015 | Televison & Video

1 Answer

Tv schematic diagram


You can try to obtain a schematic by contacting LG

Jun 18, 2013 | LG Televison & Video

1 Answer

Need to have the circuit schematic for LG 29SA1RL model


The schematic is in PDF, and cannot be send to you by this site. Check this site. It has some schematics. Check whether the schematic you need is there. Pull up older posts there.

Mar 31, 2013 | Televison & Video

3 Answers

Philips tv schematic model: 21PT3324/71


Send your email address to me by Fixya and get back a copy of the schematic by return mail.

Jan 08, 2013 | Zenith Z32X31D 32" TV

1 Answer

Need schematic for toshiba cf36g55


Send your email address to me by Fixya, and get back a copy of it by return mail.

Nov 26, 2012 | Toshiba CF36G55 36" TV

1 Answer

Need schematic for 20AF43 Toshiba TV


Send your email address to me by Fixya, and get back a copy of the schematic by return mail.

Nov 15, 2012 | Televison & Video

1 Answer

Schematic Diagram for Audiovox AVT-1475


Send your email address to me by Fixya, and get back a copy of the schematic you need by return mail.

Oct 30, 2012 | Audiovox AVT-1475 13" TV

1 Answer

I have a RCA F25216BC TV that will not turn on..the fuse isn't blown and I need a schematic


Send your email address to me by Fixya, and get a copy of the schematic by return mail.

Sep 22, 2012 | RCA F25216BC 25" TV

1 Answer

No schematic F601 blown


Send your email address to me. I'll send a copy of the schematic by return mail.

Apr 29, 2012 | Emerson EWF2004 20" TV

1 Answer

I need only the schematic diagram


Hi,
Model number and brand of tv is very important info to provide specific schematics.
Let me know model number of your Sharp tv to find out its related schematics, if I have it or provide you info as where you can get download copy.
Thanks.

Dec 11, 2010 | Sharp Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

4,060 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

69878 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6445 Answers

yadayada
yadayada

Level 3 Expert

64052 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...