Question about Ricoh Aficio 1035 Copier

2 Answers

Ricoh 1035 Display Messages

My Ricoh 1035 has a display message" Toner Is full, please call service". How can I fix that so that my machine works?

Posted by on

  • Tim Babcock
    Tim Babcock May 11, 2010

    Do you see any toner spills on the inside door of the copier or underneath the toner bottle?

  • Tim Babcock
    Tim Babcock May 11, 2010

    Do you see any toner spills on the inside door of the copier or underneath the toner bottle?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 42 Answers

Empty waste toner in transfer unit on the right side door.

Posted on Jul 04, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ricoh Master
  • 2,794 Answers

FYI

Ricoh 1035 doesn't have a waste toner bottle. It is recycled. That is why the service call message appears.

Since there isn't an SC message displayed the best thing to do is to have a service technician check out your Toner developer sensor.

What is the cycle count on your copier right now? If its around 150,000 you may need developer in your copier as well. If the developer is low, the toner might be filling up the cartridge.

Posted on Jul 04, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have Ricoh Affico MP2510. when machine display add toner notice then i add the toner but machine give message add toner


Most likely photoconductor is bad and needs to be replace you can buy them on eBay sometimes check internet

Oct 19, 2015 | Ricoh Printers & Copiers

1 Answer

Used toner bottle is full


I'm going to assume you typed the model wrong, and that it is a 1035 like the header states. If this is the case, the used toner on these is inside the transfer belt unit.
Open the duplex unit if equipped, then open up the right-side door. Attached to the door is the transfer belt unit, as see below:
602d8058-7b67-4449-895f-e01b266fd371.jpgLift the lever as shown, then lift unit out of machine. There is a panel with 6 screws near the bottom of the unit, remove all 6 screws and remove the cover. Be very careful, this thing is going to be FULL of used toner, and will make one HUGE mess if not disposed of properly. Once emptied, put cover back on, re-install unit, close doors, and you should be good to go.

Jun 09, 2013 | Ricoh Aficio 1035 Copier

1 Answer

How to find out where to read meter on my ricoh aficio 1035 copier machine


Ricoh Aficio 1035 have two meter those are the electronic counter and the magnetic counter type but they are program to synchronize. to look for the magnetic counter just open the front door and you will find it at the middle and to open the electronic counter just press the user tools/counter key located on the upper left side of your operation counter then press the counter on the LCD display. Hope this helps, thanks for using Fixya

May 03, 2011 | Ricoh Aficio 1035 Copier

1 Answer

Used Toner Bottle Full Ricoh Aficio 1035P


The used toner is stored in the Transfer Belt assembly on the right door that you open to remove a jam. Remove one spring on each side and release the catch while gently lifting up on the belt and roller assembly. It swings 90 degrees up from the rest of the assembly. There are 6 screws that hold a cover on the lower assembly. remove it and dump the waste toner. *** VERY MESSY*** have a vac on hand. Not a shop vac unless you want toner clouds floating around the office. If the six screws aren't present, dump the toner out of the **** between the mylar-rubber blade and the lower assembly. once this is done, the message will clear.

Apr 08, 2009 | Ricoh Printers & Copiers

1 Answer

Ricoh FT6645 - FULL USED TONER, CALL SERVICE


Well, it's going to be messy, but the waste toner is a big, tall container, clipped into the bottom right side of the machine(where the paper feeds up the side. Remove it ,and get yourself a big plastic bag, and start dumping. WARNING: There is no easy, clean, way of doing this. That's why it is typically removed and replaced with a new one, but go for it, if you feel up to it.

Good luck!

Apr 06, 2009 | Ricoh Printers & Copiers

1 Answer

Ricoh Aficio 2027, Service Code 320


dear sir; the error code 320 on ricoh af 2027 it's means laser polygon motor problem, the laser unit right under the toner unit, litlle bit left. some error code can be reset why don't give them a try
1, power on the machine
2, press "clear mode"( has the c in a diamond), "107"then press and hold down "clear/stop" key
3,turn power off 10 second later back on.
I f reset doesn't work, you need to replace laser motor. thank you
HAVE A HAPPY HOLIDAY

Dec 17, 2008 | Ricoh Aficio 1035 Copier

4 Answers

Used Toner Bottle Full Ricoh Aficio 1035P


The used toner bottle is not actually a bottle at all. Not sure what you emptied, but it sounds like the actual toner bottle itself. The waste toner is contained with in the transfer belt unit. When you open the right side cover, this is the unit that is attached to the door. It is a brown belt that provides transfer of the image to the drum and separates the paper from the drum. Remove this unit by locating the release levers on either side of the transfer unit (push both of them towards the machine). After removing, you will need to actually take the belt unit off of the transfer unit. To do this, remove the two tension springs on either side, and then take a small flat bladed scredriver and release the clips that hold it down (you will see when you get started). Once you get it off, you will see the long blade that actually scrapes the toner off the belt. Dump the waste toner out this end. You will need to shake it pretty hard. A better (and cleaner) option is to vaccum it out using the crevace tool on you vac. Just make sure you completely empty it. Now....do everything in reverse.

Hope this helps,
Chad

Oct 07, 2008 | Ricoh Aficio 1035 Copier

2 Answers

Problem with aficio 1035


The developer should probably be changed in it. the cartridge should be inspected as well. Was there any toner spills?

Jun 21, 2008 | Ricoh Aficio 1035 Copier

Not finding what you are looking for?
Ricoh Aficio 1035 Copier Logo

249 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ricoh Printers & Copiers Experts

quennie732

Level 2 Expert

393 Answers

Bernard D'Souza

Level 2 Expert

161 Answers

OfficeServiceAjnc
OfficeServiceAjnc

Level 2 Expert

181 Answers

Are you a Ricoh Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...