Question about Projection Televisions

1 Answer

Tv picture is pixalated (blocking) - Projection Televisions

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 51 Answers

It probably realted to a weak signal from source(antenna, cable or satelite box) if a direct source like a dvd player works fine its for sure your source.

Posted on Jul 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I look for the Hdmi with remote going through input and can't find


Check out this page
http://pdf.textfiles.com/manuals/STARINMANUALS/JVC/Archive/AV-48P776,%20AV-56P776.pdf
Could be that the pixels on the Ipad are set to high for the TV at the bottom left it shows what the pixals are accepted.

May 01, 2014 | JVC AV48P776 48" CRT TV

1 Answer

I have now 3 white dots like pixals blown


The model number almost certainly is a wd one.

Set is a DLP set with a lamp and 98% chance the optical light engine is the cause. Some of these start with one or two out and gradually it can get worse with more and more appearing over time.

It is about the most expensive part in the set.

Sorry, but I have seen them since the first DLP sets came out.

Dec 05, 2012 | Mitsubishi Projection Televisions

1 Answer

My Samsung DLP TV S4266W has snow all over the screen. I've been told I need a new motherboard. Is that true? How much would that cost? Can I buy and install it myself?


Had this problem it is cosd by a befect in a chip call compy and thay will repace for free........no matter how old your set is take care

Jul 18, 2012 | Samsung HL-S4266W 42" HDTV

1 Answer

Sony rear projection tv model KP-53V15 turns on, have sound but no picture, after a while, picture comes on, but later goes out again, picture keeps coming and going. Where do I start looking?


Adjust Screen Volts (G2) of all 3 picture tubes and screen volt control knobs are on focus block located under speaker grills at front of TV.
Remove speaker front grille of TV, look for focus block that has 6 control knobs, 3 knobs are for focus and 3 for screen volts, increase volts by turning little bit control knobs of screen volts and this will solve your problem.

Nov 02, 2009 | Sony Projection Televisions

1 Answer

Getting dark picture.. is there such a thing as


yes it is noy pixal oil it is CRT coolant there are several companies on-line that sell complete collant replacement tvrepairkits not to hard to do with the directions given and a lot of times the sets look as good as it did when it was mnew!!!!!! Good Luck
Larry Dillon

Aug 27, 2009 | Projection Televisions

1 Answer

While watch tv last night heard a crakle and we lost the picture on our samsung dpl tv. We got a new lamp and installed it. There is still no picture.


Sounds like the color wheel has shattered and the sensor is blocked by the peices. If the wheel was not blocked you would have a black and white picture.

Jul 06, 2009 | Projection Televisions

1 Answer

Pixelation


This model has been known for problems with the Hyper module but the picture would be affected with any input source.HD or not.The cable converter box and the cable signal are the only culprits for pixilation.Pixalation is the result of missing digital information via signal.If it is only appears on the HD signal I would suspect the cable signal or the converter box.I assume you are using your component input on your TV or the HDMI input.As a technician I would suspect the cable box or cable for pixalation.

Jan 19, 2009 | Toshiba 46H84 46" Rear Projection...

1 Answer

Having digital problems


Check your signal to the tv, if all is good then you are looking a t Q Box assembly most likely

Dec 27, 2008 | Sony Grand WEGA KDF-50WE655 50" Rear...

1 Answer

Child Lock is on and I am second owner of tv with no code


This function will block out the picture and sound of the selected channel or video input.
It can also be used to keep the TV from being viewed for a scheduled time period that you set.
The code to enter the Locks feature is a four digit secret code number. The factory preset code is 0000.
Use the number buttons to select access code.

Use CURSOR G or H to highlight function and then press the SELECT button.
To change the access code number, select Change Access Code. Enter a new four digit key number you prefer.
Select CHANGE ACCESS CODE to change factory preset code (0000) to your preference.
When ENGAGE LOCK is selected, SET CHANNEL LOCK, SET INPUT LOCK, and SET FRONT PANEL LOCK can be set individually.
When SET CHANNEL LOCK is turned on, the picture and sound for the chosen channel will be blocked out.
When SET INPUT LOCK is turned on, the picture and sound for all video inputs and the picture and sound for channels 3, 4 will be
blocked out.
When FRONT PANEL LOCK is turned on, all buttons on the Front Panel will be deactivated, except the Power button.
When TV TIME LOCK is turned on (r TIME LOCK) you can set the BEGIN and END times (CURSOR E) and the TV
cannot be viewed during that time period (Set clock first). Use CURSOR G or H to highlight ONCE (TV will time out one time
only), DAILY (TV will time out every day), WEEKLY - SUN~WEEKLY - MON (TV will time out one time a week) or OFF (to disable
this function).
When MOVIE RATINGS is selected, you can block various types of movies and video tapes based on motion picture ratings. Picturein-
Picture will also be blocked automatically (see page 45).
When TV RATINGS is selected, various types of television programming based on a parental guide ratings will be blocked.
Picture-in-Picture will also be blocked automatically
If you forget your secret code, use the factory code 7777 to erase your key number. This will reset the secret code number back to the
factory preset 0000.
Press EXIT to quit the menu.

Dec 07, 2008 | Hitachi 57F500 57" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...