Question about Lowrance GPS Devices

1 Answer

I have a lowrance lms-522c. I am having problems leaving a visible trail.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Followed the instructions that the manual gives to show trail.

Posted on Jul 04, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Lowrance completely dead


my lowrance lms 337c df will not power up. I checked all the cables and poer and they are good . can you assist me

Aug 14, 2011 | Lowrance LMS-337CDF GPS Receiver

1 Answer

Hi,when i switch on my lms-332c the map does not come up on the screen.If I remove and replace the map card it works perfectly. Can I fix this? regards nigel


I am guessing that the card you are using is a NAVIONICS chart? There have been some Lowrance units that were made around the same time that have had problems recognizing a Navionics chart right from power up.

Make sure the LMS-332 has the latest firmware version which can be downloaded from http://www.lowrance.com/en/Products/Marine/Full-Size-SonarGPS-Chartplotter-Combos/LMS-332C/Downloads/LMS-332C-Software-Update/

If the update doesn't help, this is going to be a compatibility problem with the LMS-332 and that particular card. You will need to replace the card or upgrade to a newer unit...but probably can just get used to removing and replacing the card when you turn the unit on.

Jul 08, 2009 | Lowrance LMS 332c Mapping Sonar/GPS...

1 Answer

I have a lowrance LMS 332C GPS. After 5 years I


The LGC-2000 is bad would be the most likely cause, but if this started right after you changed the cables, Try connecting the NMEA 2000 network to a different power source than the main power. If you still have the original cables, and you didn't have the problem before, try using those again to make sure there isn't anything wrong with any of the new cables.

But most likely, the LGC-2000 is toast and you will want to contact Lowrance support to see about getting it repaired/replaced.

Jul 04, 2009 | Lowrance LMS-332C GPS Receiver

1 Answer

Lowrance lms 330


have a lowrance lms-330c the depth no. keep changing from hi no. to low no. can not stop it,,, will not show true depth,,, can you help?,,,where can i send it to get it fix?

May 29, 2009 | Lowrance LMS-330C GPS Receiver

1 Answer

Lowrance 330c screen says '' boot failed''


Try a hard reset:

1. Turn the LMS-330 off
2. Press and hold the ZIN, ZOUT, and PWR buttons
3. Release the three buttons once you see the "warning, do not rely..." message appear

If you get that far, the problem is solved. If you get boot failed again, try installing the latest update which can be downloaded from http://www.lowrance.com/en/Downloads/Product-Software-Updates/

If you still get boot failed, you will need to get the LMS-330 repaired/replaced. You can contact Lowrance support at 800-324-1356 or email them by going to http://www.lowrance.com/en/Support/Product-Support/Contact/

Mar 22, 2009 | Lowrance LMS-330C GPS Receiver

3 Answers

My Lowrance LMS-337c df keeps going crazy.


Normal 0 false false false MicrosoftInternetExplorer4 st1:*{behavior:url(#ieooui) } /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;}This could be caused by glitch in the operating systemsoftware or by low voltage due to a short in the unit or somewhere in the boatswiring. To troubleshoot the problem Iwould recommend the following steps.

  1. Try a soft reset
  2. If the problem resurfaces, try a hard reset
  3. Update the the operating system software

Soft Reset (Does not delete GPSData)
1. Turn unit OFF 2. Press and holdthe PAGES key
3. Press and hold the PWR key
4. Release both buttons when the USA map
Appears

Hard Reset (Deletes stored GPS Data
such as Waypoints and trails)
1. Back up any waypoints, routes,and trails that you want to save on a blank MMC card
2. Turn unit OFF
3. Press and hold the ZIN&ZOUTKeys at
the same time
4. Pressand hold the PWR key
5. Release both buttons when the USAmap
appears

To update the operating system software, check out this link:
Lowrance337c df update


If you don't have a card reader I can program an update card for you.


Dec 15, 2008 | Lowrance LMS-337CDF GPS Receiver

2 Answers

Gps


I have a manual for this unit but i'm still using mine so not willing to sell it to you. I'm in Melbourne and you're welcome to borrow it for a week or so or i could probably photocopy/scan certain sections for you and email them if it helps. Let me know if you still need it by emailing me at joshklat@hotmail.com

Cheers,
Josh

May 21, 2008 | Lowrance LMS-337CDF GPS Receiver

Not finding what you are looking for?
GPS Devices Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lowrance GPS Devices Experts

buzz flewhart
buzz flewhart

Level 3 Expert

655 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

10719 Answers

kakima

Level 3 Expert

96664 Answers

Are you a Lowrance GPS Device Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...