My tony hawk SHRED board controller will not calibrate.. any suggestions?

It's possible that walls, people, or other entities are triggering the IR sensors on the sides of the board. To prevent this issue, make sure that there are four feet of free space on all sides whenever playing and that there are no large metal objects nearby.

Return to the main menu and select "Options", then select "Calibrate Board" and follow the onscreen instructions. Make sure to follow the steps exactly and hold the board in the calibrating positions for the amount of the time the video that is play is telling you.

During the initial IR sensor calibration process ensure that you are standing away from the board and that you are motionless. When it is time to calibrate each individual IR sensor you will then be shown some positions on the board to hold. Ensure that your entire foot is covering the lens of the particular IR sensor you are instructed to cover. Also ensure the board is facing the right direction. The buttons on the board should be on the left side of the board. Cover the whole sensor for the full count. Tony Hawk will say "Got it" when the timer is finishing. Continue to hold that board position until the button prompt to continue appears. Stepping off of the board before that will cause an error even after Tony Hawk says "Got it". You do not need to press a button to continue to move on to the next step. The calibration video will move on to the next step on its own.

If you still have issues with the calibration then try lowering the lights in the room. Sometimes bright lights can interfere with the IR sensors.

hope this helps

John

What worked for me after returning 4 times was to set the sensor settings in the wii settings to below the tv but put the sensor above the tv with 2 old and 2 new batteries

try using two old batteries with two new ones, also try putting the board on a small stool just whilst calibrating, it worked for me, good luck!

try using two old batteries with two new batteries and putting the board on a small stool whilst calibrating, it worked for me, good luck!

You need to connect the board to the XBOX before you can calibrate...press the Connect button on the main console (on my XBOX 360S it is directly to the left of port 1 for the game controller), then press and hold the tiny button far left on the board controller. That's as far as I got, it won't calibrate to save my life!

we spent a day trying to calibrate the shred board, after much searching on the internet we found the solution that worked for us straight away was too - put two old and two new batteries in the board, we also elevated the board on a small stool this did the trick and now we can actually use it. Huray!!!

try using two old batteries and two new batteries, also why calibrating try putting the board on a small stool - this worked for us. Good Luck!!!

you not the only one, same thing with me and 90% of other who got this for christmas

Use older batteries. Do not use the batteries that came with the board. After you switch the batteries re-calibrate and it should work fine.

I had the same problem. Do not use the batteries that come with the board. Use slightly older batteries and re-calibrate the board, this should work.