Question about MGE Galaxy 3000 UPS System

2 Answers

UPS not charging

Sir,
Our UPS is not charging at all. After following the procedure for shuting and starting up, it show battery charging 0%.

The model is MGE Galaxy 3000 UPS

Thanks

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Sir, Our UPS is not charging at all. After following the procedure for shuting and starting up, it show battery charging 0%. The model is MGE Galaxy 3000 UPS and also cooling fan is going to falt mode .with best regards

Posted on Dec 01, 2008

Normally to diagnosis this problem you need a special diagnostics software.Nevertheless,the ups needs to know that battery is present before to give a charge current.
i will advice you see with a mge representative in your locality

Posted on Jul 04, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

May ups some times shuting down and it alarmed fault ligth red


Hello, it is possible that the battery inside the UPS needs to be replaced as it may no longer be able to hold a charge. If you can test the battery for voltage, and it is less than what it should be, replace the battery. If the battery is what it should be, then your UPS has malfunctioned, and there is not much you can do to fix it.

Thanks for using FixYa!

Jul 08, 2011 | Powerware 9120 UPS System

1 Answer

I have model G1010USB battery backup and it has been plugged in for more than 48 hours and the battery capacity has never changed and showed it the battery is charged up or not it, the boxes just stay...


Is this unit new or used? Either way, the first thing to check is if the battery is plugged in. UPS units are shipped with one of the battery leads disconnected for safety purposes. Please remove the front plastic bezel and verify the battery is plugged in. If it is new, and you followed the instructions correctly, you could have a bad battery or charging unit in the UPS. Please contact technical support for the manufacturer.

If you have a used UPS, disconnect the battery connections and use a multimeter to check for existing voltage on the battery. If it is completely dead after a charge cycle, it is quite possible the battery is bad and needs replacement.

Mar 05, 2011 | Tripp Lite HT1000UPS (037332125262) UPS...

2 Answers

Hi i m using powercom ups but whenever i make the connections my computer restarts againand again i dont know why???


Friend have you plug and switch the ups properly, If so then check that you have also plug your computer pin properly into a ups. If this is also right then there might been problem in a UPS charging or in ups. It might also be a system fault. Just check out the system fault by applying the direct connection to the socket. If this solve your problem then check out all the procedure of ups to work and if this does not solve problem repair ups or charge it properly. If the ups is also not charged then it also make a problem to start for sometime.

May 13, 2010 | Computers & Internet

2 Answers

Ups starts beeping


Is there any indicator lights ON showing the fault condition?
This could indicate that the battery has a low charge. Even if you switch off the mains supply and it switches over to the battery, the UPS may shut down after a short time as the battery power (charge) runs out.
If the battery is more than 3 years old then it may be due for replacement.

May 10, 2010 | Powercom BNT-1000AP (dspcmbnt1000ap) UPS...

1 Answer

Sir, my UPS 500va did not work when power is interrupted. what should i do? thanks...


The way UPS works is that, there is a 12V sealed lead acid battery inside the unit which gets charged when the power is on. When the power goes off the battery power is converted in to 120 VAC. It is likely that your battery needs replacing depending how okd it is or it does not charge.

Dec 18, 2009 | Computers & Internet

1 Answer

U p s by pass l e d flashing light


Batteries in the UPS typically last 3 to 5 years and it depends upon several factors. Including the number of times the unit must go on battery power and environmental conditions. There are usually several batteries in the UPS and while the battery voltage may show 13 volts, this may only be a float charge/voltage and a true indication of the battery voltage and condition requires the batteries to be tested under a load. If one battery is faulty in a set of batteries it will causes the whole battery system to fail and indicate a battery fault.
A faulty charging circuit will not charge the batteries and will also cause a fault condition.

Nov 29, 2009 | Liebert (PS2200RT2230) UPS System

1 Answer

Apc unit is shuting itself down whenever PC unit is turned on, and then its alarm gets stuc. Also, sometimes it shuts down whenever another electrical appliance in the room is turned on. (Like a TV)


Batteries in the UPS typically last 3 to 5 years and it depends upon several factors. including the number of times the unit must go on battery power and environmental conditions. There are usually several batteries in the UPS and while the battery voltage may show 13 volts, this may only be a float charge/voltage and a true indication of the battery voltage and condition requires the batteries to be tested under a load. There maybe one battery in a set of batteries that is faulty and causes the whole battery system to fail and indicate a battery fault.

These lower powered and cheaper KVA type UPS are switch over types, when the mains supply fail, the UPS switches over to the inverter in milli-seconds which then supplies mains power but the power waveform is a pseudo sine wave (ie not a true sinewave. A faulty inverter circuit won’t deliver power when the mains supply fails.

Oct 24, 2009 | APC BE500U ES 500 USB BACK-UPS 500VA/300W...

2 Answers

UPS not charging


check your fuses some fuse blown.

May 27, 2009 | MGE Galaxy 3000 UPS System

1 Answer

UPS is not showing AC light on i.e Green light


It does not look good for this unit.
Time to upgrade, go bigger. Maybe this unit is too small for you system. Most likely a 1000VA will solve your problem.

Sep 10, 2008 | APC Back-UPS CS 500VA UPS System

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

2,621 people viewed this question

Ask a Question

Usually answered in minutes!

Top MGE Computers & Internet Experts

yadayada
yadayada

Level 3 Expert

63815 Answers

Jax Planet
Jax Planet

Level 2 Expert

921 Answers

Christopher Thrash

Level 3 Expert

425 Answers

Are you a MGE Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...