- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi,
How are you this is jack my id [email protected]
your copier toshiba 161 show H...4
Dear, Follow the procedure.... press C(CLEAR) BUTON+ PHOTO BUTON+C BUTON+PHOTO BUTON..... Your copier enter special mode
Then you press 14 and start key.... copier ...ok
PLEASE VOTE ME
Thanks,
Best Regards,
does not solve these problems H2? substituted
for the other thermistors, but still nothing same error ... The whole
problem of the scheme not remove the plug from the power supply and
printer cable recorded the error, which now does not solve ... help
??????
U can enter simulation mode and input "14" to clear the message.
If happen again, u need to check following: Thermistor Control PWB Fusing section connector disconnection The fusing unit is not installed.
Perform the following procedure to enter the simulation mode. "C" key AUTO/TEXT/PHOTO key "C" key AUTO/TEXT/PHOTO key Main code Start key Sub code Start key (Note:Perform the first four key strokes quickly allowing no more than one second between key strokes.)
1. Entering the simulation mode
Perform the following procedure to enter the simulation mode.
"C" key AUTO/TEXT/PHOTO key
"C" key AUTO/TEXT/PHOTO key
Main code Start key Sub code Start key
(Note:Perform the first four key strokes quickly allowing no more than one
second between key strokes.)
if the machine dies enter the code 14, then press start, the machine wil reboot and the problem wil be solved, if not , contact your nearest service centre
estudio
×