Question about Denon Audio & Video Receivers

1 Answer

Hi, I have a denon 2407 receiver that i have not been able to set up to perform the multizone function. I had sound coming from speakers at a very low level, then the amp would shut down. I assume that something was a miss. Do you have a set up procedure that works? or is there some trick that i can't see in the manual? any help would be great.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 151 Answers

Make sure that each speaker has its own cable to the amp ,if they are linked together they will present a heavy load to the amp and it will switch off to protect itself.
hope this helps.
CABLE GUY.

Posted on Jul 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No sound from Denon AVR 988


make sure the TV audio setting is set to send sound through to the Denon not just out of the TV speakers, you wont be able to do both

Mar 17, 2014 | Denon AVR-988 7.1-Channel Multizone Home...

1 Answer

No Sound in Right Front Speaker- Denon AVR-1508


hi there,

have you check the system settings for each of the speaker..? should be set and balance all output of the speaker

`jack

May 24, 2008 | Audio & Video Receivers

1 Answer

I hv a Denon AVR 3805, i tried to set it up but after doing all the necessary, i found out that it was only running on 3 speakers (FL,FR & SW). I did connect the center speaker but the sound just...


SW means sub woofer, not necessary means center speaker in all receivers. Instead of setting 5ch stereo, if you have 3 speakers. try to set "3channel" or "simulated". If you own more than 3 speakers, you may refer to the user´s manual to correctly wire them to get the full sound.

Sep 18, 2010 | Denon AVR-3805 Receiver

1 Answer

Denon avr-587


Make sure that the volume is not muted or too low on the TV...the TV volume output to your receiver will be performing the function of a pre-amp to your receiver. Then select the appropriate input on the receiver that you have the TV audio connected to.

Jul 17, 2010 | Denon AVR-587

1 Answer

Connecting computer speaker to a receiver


Which output section of the Denon are you using? Tape monitor out? And are you getting sound through the speakers (not the PC speakers) that are attached to the Denon speaker terminals?

Oct 26, 2009 | Denon AVR-1601 Receiver

3 Answers

I want to get full surround sound out of my Denon AVR-1508 w/sub


hi there might be some problem with the link that u have hooked up with the speakers.

Jan 18, 2009 | Denon AVR-1508 Receiver

2 Answers

Denon AVR-3805 zone 2 no longer working


time to reset the microprocessor. See page 87 in manual.
1) switch off the unit using the main unit's power operation (small power button)
2) hold the PURE DIRECT button and DIRECT button at same time and turn the main unit's power operation on.
3) wait for entire display to flash in 1 second intervals

now the speakers need to be set up again but zone 2 will be working. i suspect a power surge causes the microprocesser to be corrupted. i put a power surge protector and have not had problems (lately).

Dec 29, 2008 | Denon AVR-3805 Receiver

1 Answer

Denon AVR 2807 with Bose Acoustimass 15


Well,i can tell you are not very focus,cause you posted Denon AVR-2807 with Bose AC 15 problem,but under your details,you put down AVR-5807!
First of all,it is so unfortunate that you are NOT able to gain and experience to true ability in sound for this wonderful receiver when you are using a dual tweeters speakers and expect to have good sound separation as a TWO WAY speakers(a tweeter and a midrange-for true high frequency and mid frequency sound separation.)
Secondly,you have defeated the audio configuration of the Denon AVR-2807,since all your speakers are control BY the Bose subwoofer.
Now,i could show you a way to hook this up,and it doesn't matter how you connect them, they are the "bicycle tires" installed with a "Porche"engine if you know what i mean.
If you want a good recommendation for your "beast",i will more than happy to show you the way!
Cheers,
solutiondoct

Sep 28, 2008 | Denon AVR-2807 Receiver

1 Answer

DENON RECEIVER TWO ZONES


yes you can enjoy of multi zone function which allow you to listen in two different places at same time.(main room& sub room).

Aug 06, 2008 | Denon AVR-1803 Receiver

Not finding what you are looking for?
Audio & Video Receivers Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Denon Audio & Video Receivers Experts

 Elex
Elex

Level 2 Expert

49 Answers

jonpoint

Level 1 Expert

4 Answers

Tech Leprechaun
Tech Leprechaun

Level 2 Expert

61 Answers

Are you a Denon Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...