Well you I brought a playstation3 and when the game is on there is aline that travels from the top to the bottom. Now we have been playing games on the TV for about two years and have never had this problem before. Everything is connected and you can see the game fine and hear it. I just want to know what to do next.
An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: There are running line on the screen
There is no way to fix it unless you get a A/V cable set for the PS3. HDMI isnt really a very good video + audio standard. the lines are just extra data that travels throgh the PS3 and ends up on your screen.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You must reset your PS3 in order to accept the new TV configuration.
If the video output settings on the PLAYSTATION3 do not match those of the cable or TV in use, there may be no picture. If the screen goes blank, turn off the system.
Then, with only the PLAYSTATION3 and the TV connected, touch the system's power button for more than 5 seconds to turn the system back on. The video output settings will automatically be reset to the standard resolution.
Hope this helps please remember to rate my response, thanks!
Contact Sony and tell them the problem. As long has youve had the playstation3 for under one year and have not touched the warranty seal at the side of the playstation then you can have your old playstation3 replaced.
Do you mean the touch screen?
Have you tried the alignment procedure?
Remove any cartridges and go into the setup by pressing the small icon at the bottom center of the screen when you first turn on the ds.
Press the yellow square (alignment) and follow the instructions.
i found a REALLY easy solution! the most likley problem is that there is dust in the GBA/DS game card slot! it corrupts the connectors (i dont want 2 explain how it gets into the system) so step one: wrap a small peice of tissue around the stylus(make sure DS is turned ON)
step two: LIGHTLY go inside the GBA/DS slot with the tissue wrapped stylus.
step three: shut down DS system and turn on again
problem solved! hope this helps.
Hi I have a problem with my bottom screen as well. I was replacing the case as the hinge was broken. When i was putting it back together i noticed a slight tear in the ribbon cable which is attached to the board and the bottom screen. When I turned it on I found I had poor colour and contrast in the bottom screen however the top screen was fine. Where this ribbon cable is attached to the board there is two small cables attached to the board beneath it, maybe one of these has come away and needs repositioning or your bottom screen needs replacing.Try this site for diy tipshttp://site.powergamingparts.com Cheers Chris