The lazer on my mouse turned off and its brand new, what shoukld i do?

If wireless, change battery.

you will need to purchase the set as the transceiver is paired with each - saw units on ebay starting at $30 and it appears Best Buy has them at ~$50

Most likely you will not be able to find schematics or parts for your mouse since it was most likely made in China and a new mouse is cheap.

mouse is damaged you open it will found 1 wire not connected

Do you mean you might used it on you lap rather than the desk and have changed the angle of the mouse? It will be the lazer, (if changing the angle of the mouse works). Disruptions occur with the lazer, hey they don't wear like a ball mouse does. You can have it repaired, just have to decide if it is cheaper or easier to just replace it. (Tip, don't leave it in direct sunlight when you are away from the computer. It shortens the life of a lazer mouse).

Replace the batteries.

whe u installed you mouse, you installed it from the cd from targus..right? so there is some settings in that program that you can change so when you turn on your laptop the bluetooth seeks for bluetooth items and it will find your mouse. I know its a little bit tricky but you can fix it, find the settings, change them and you dont have to buy a new mouse.

When you turn of your laptop the cooonnection betwen the item is lost, when you turn on you laptop i asume that your bluetooth is now passive, by making it active it starts immediately search for bluetooht items.

Good luck!

Ok, if you open up the mouse, there is a little piece of plastic that presses down on a button in the mouse, if the right click doesn't work, that little piece of plastic is probably broken. I know you like that spongebob mouse, but you'd have to get a new one. Check ebay.

Hold the reset button on the bottom in

Start by removing the battery cover.. there is a screw on either side of the battery compartment. this will allow you full access to the contacts for the buttons and the wheel Good luck