Smelly television we have a toshiba tv about 10 years old, it recently keeps giving off a bad smell form the back! It doesn't smell electrical but it is too bad to watch! We have had no other problems with it, please help.

need to replace ballast

I think the problem is coming form your lamp if you have not replaced it before but if you just recently replaced it then I would have to say you have a bad ballast here is a store that carries your lamp


http://www.discount-merchant.com/SearchResults.asp?Search=62HM95

Im pretty sure its not the television. You are getting interference from either through your cable box or your electric in the house. Possible bad dimmer switch.

check the speaker

I have also recently been given a 10 year old nec n4858 tv and would like to know how to tune in the stations?

Peace aminajmay,
ngafm At your service!


Sounds like an electrical fault.
If I were there hands on I could be definite.

Only a hands on laundry tech can make the diagnoses.

BUT, how old is the washer?

If the appliance is 10 years old or more you it may not be advisable to put good money into bad!
New appliances are so much more efficient today that they can save you a lot of money in energy!
Water,Electric and detergent! And put money back in your pocket!
The new appliance will pay for itself in only a few years!


Bless You ngafm
PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OFF

Thank You

Dear friend,
ngfam at you service! happy to assist!

Whirlpool sells odor stoppers for your fridge!
And keep a open box of baking soda on the door always!

HERE IS THE WHIRLPOOL SITE BELOW

http://www.whirlpool.com/catalog/
accessory_category.jsp?parentCategoryId=
323&categoryId=370



How old is the appliance ?
If it's 10 years old or more it's not worth sinking good money into bad !Todays appliances are so much more efficient that you save money on you electric bill!

Below I gave you a nation wide service thats very good!

We sell appliances for 65 years and I recommend this nation wide Factory repair service!

Call A&E Factory Service /They service nation wide
And are available 24/7 for making appointments!

If the appliance is 10 years old or more,it may make sense not to invest any money to fix it!

Happy to assist you,
PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OFF!

They may have gotten some cheap convergence ICs, thats a real possibility. I would recommend switching the two origional STK392-110 with some STK392-150 they will run alot cooler and last alot longer. Just use a good coating of heat sink compound on the back of the ICs. I will post a link where you can get top quality Convergence ICs and they provide free instalation instructions with pictures so you can do the job yourself in under an hour and save quite a bit of money. Heres the link.
http://servicemanuals.vstore.ca/

Bad solder connect inside tuner = un- solder tuner from
PC board and solder bad connect or replace tuner with new..
I.F. block next to tuner should be soldered,also.......T.

try letting it sit for 15-20 minutes unplugged from the wall and maybe try another outlet depending on if u got plugged in to a power strip, possibly pulling to much power from that perticular outlet.