Question about Sony FD Trinitron WEGA KV-32FS120 32" TV

Open Question

Sony Trinitron problem

I have a Wega Sony trinitron SRS BBE 27" TV that is stuck on cable box when you turn on the TV. Nothing happens when you hit the menu button on the TV or any of the other bottons. How can I get a picture back on the TV?
It does not seems to recognize the remote either.

Posted by on

  • Dave999 Jan 09, 2009

    I just recently programed my direct tv control to the tv. It worked fine for a week. Suddenly, when I turned the tv off and back on, there was no screen anymore. The audio works, but no video. I even tried disconnecting everything and turning it on without satalite. The tv does not want to play anything but audio. What should I do?

×

6 Suggested Answers

  • 1 Answer

SOURCE: Sony WEGA Trinitron SRS BBE 32'

How do you get the green display off of the tv screen?

Posted on Jul 04, 2008

  • 59 Answers

SOURCE: Getting green display off of tv screen.

use the remote and press the display button

Posted on Jul 04, 2008

welcomejee
  • 10594 Answers

SOURCE: Sony WEGA Trinitron SRS BBE 32'

Hi,
Please reply couple of questions about TV to guess what could be wrong.

1- How many times standby light blinks, there would be interval of 3 seconds in blinks so count pause to pause.

2- Please intimate exact model of TV, written on sticker pasted at back of TV. That will help me to check its schematics.

Hit " add a comment" button to reply.
Thanks.

Posted on May 03, 2009

stonephoenix
  • 563 Answers

SOURCE: Sony FD Trinitron WEGA KV-32HS500...red standby light blinks 6 ti

I have over 10 years experience in electronic tech support.

I know this isn't what you want to hear, but the problem you've described can't be fixed with
troubleshooting. Your TV will have to be repaired. There is a part that has developed a defect and needs to be replaced. If you're still in warranty, the TV will be repaired at no charge to you. The warranty would likely be at least one year from the date of purchase from the manufacturer. If you purchased an extended service plan they will repair the TV at no charge as well.

If the TV is no longer in warranty, it will likely cost a minimum of $150 parts and labor. This is assuming that you only need one
circuit board or small part. If the problem is more than one of the circuit boards, the price of repair could go much higher.

I hope I've provided you useful assistance and that this information allows you to make an informed decision as to how to proceed from here. Please be sure to vote on my response. I hope I've earned a good rating from you today.

Please let me know if I can be of further assistance.

Posted on Jul 11, 2009

  • 115 Answers

SOURCE: Sony FD Trinitron WEGA KV-32FS120 timer flashing 9 times

WARNING- VOLTAGES STORED INSIDE YOUR TV CAN KILL YOU EVEN AFTER ITS BEEN UNPLUGGED FOR DAYS..your problem is in the zero cross detect circuit . youu should take it to a repair facility. -Or replace diode D647 . Or on remote in this order press "display -5- vol down - pwr ." and then you could watch it right now ..kinda

Posted on Oct 01, 2009

Testimonial: "Thanks for the amazingly quick response. This is very helpful information."

SOURCE: Sony trinitron Srs BBE stand by light blinking and

ONE: Unplug it for at least 4 hours. That is what we call a hard reset.

TWO: If the hard reset does not help, then it will need further diagnostics.

The following bulletin may be of help in your learning about what is going on. Please refer to it below. Then let me know if you need further assistance.

Have a great day,
Cleggsan
========

Sony Blinking Codes
Many of the later model Sony TV's have a built in Self- Diagnosis function. If
the timer/standby indicator is blinking, this could be an indication of the
problem with the unit. The diagnostic blinking will occur automatically with no
action required by you to engage it.
The timing of the blinking you see would be as follows: two to eight blinks
(depending on the fault) about a third of a second apart, then pauses for 3
seconds, then the two to eight blinks about a third of a second apart again.
Here is a list of the problems that might have occurred indicated by the
number of blinks. The words in parentheses are those which you will see for
each of these faults on a diagnosis screen described later in this article.
Unit is dead and there are no blinks---Problem in the standby power
section. Might check fuse, R607, Q601, IC601, R612 and VDR601 (should
show open)
Continuous Blink Once A Second, No Pausing As Discussed Above---
No reply from the jungle IC301 (data bus is busy, shorted to ground or held
high), IK video path is defective.
ONE Blink--- not used for the self-diagnosis
TWO Blinks---B+ over current protection (OCP) , unit goes to the standby
mode then displays the 2 blink fault. Could be a short in the power supply of
any of the circuits.
THREE Blinks---B+ over voltage protection (OVP), unit goes to the standby
mode then displays the 3 blink fault. This is also a problem in the power
supply circuit, check T603 and R672.
FOUR Blinks---No Vert. Deflection (V STOP), Screen goes to a single
horizontal line then the video signal muted. Check IC1509, Q1505
FIVE Blinks---AKB circuit (AKB), the timer/standby indicator blinks for about
30 seconds then goes to the self-diagnosis function. Something is wrong with
the video. Check video out, Q705, 732, 761 and other components on the C
board, also check Q218, 219, 220 on the A board. Also unit be in IK blanking,
try turning up screen slightly.
SIX Blinks---No Horizontal (H STOP), no raster, goes to the blinking selfdiagnosis
function immediately. Check C515 & 516 and the jungle IC, IC206.
SEVEN Blinks---High voltage shutdown. The high voltage has exceeded 33k
and the unit goes immediately into safety shutdown. Check power supply
regulation and horizontal circuits.
EIGHT Blinks---Problem with the audio (AUDIO), unit goes to standby and
blinks the self-diagnosis code. Check IC406 audio amp, PS401 and 402.
Intermittent problems ?? This is a great feature. You can also bring up
these fault codes ON-SCREEN to see a list of the problem numbers with the
abbreviation of the problem and the number of times this problem has
occurred. This is slightly different than entering the service mode. To see the
diagnostic screen, Press the following buttons:
Display, Channel, 5, Vol Minus, ( Not plus ) then Power. This brings up
a screen with a list of the problems and number of times they have occurred.
Each of the problem names is abbreviated as, "OCP", "OVP", "V STOP", ETC.
We have repeated them in parentheses in the text for the "Blinks" described
above so you can correlate between the diagnostic screen and the blink
codes.
So, now that you know about these self-diagnostics, how do you use them?
Say that you have a set with a black screen. You see that the LED is blinking
4 times....This would tell you that you have no vertical and that is why the
video is muted. If it was blinking 6 times, you would know that you have a
horizontal fault.
It's not a sure cure, but it's a little better than a poke in the eye with a sharp
stick.
IMPORTANT: after you repair the unit, PLEASE clear the values on this
diagnostic screen. These codes do not reset themselves after the fault is
corrected, so if you don't clear them, you'll be seeing "old" fault codes the
next time you enter this screen.
Clearing is done by going into the service mode ( display, channel, 5,
volume plus, then power ) then press 8 and Enter, which of course returns
everything to the factory preset condition.

Posted on May 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need cable tv for sony trinitron bbe


have you been select ' cable ' at the settings of your tv. then where did you hooked up the cable box at the tv ?.have you been tried to reset the cable box.

Dec 04, 2012 | Standard (CRT) Televisions

1 Answer

Describe your Sony FD Trinitron WEGA This started


I have the exact same problem. If you get anywhere (I can't) please contact me at tbiasi@hotmail.com. If I figure it out, I'll get back to you.

Good Luck.

T

Sep 09, 2009 | Sony FD Trinitron WEGA KV-27HS420 27" TV

1 Answer

Menu Screen pops up, try to exit and goes to video 1


This could be a stuck button on the front control panel or a bad solder connection on one of the switches on the front control panel.

Aug 02, 2009 | Sony FD Trinitron WEGA KV-27FS100 27" TV

1 Answer

STANDBY LIGH BLINKING 9 times...


I have a Sony SRS BBE Trinitron (WEGA). The last few days when I tried to turn it on using the remote the Red Light would go on but the TV did not turn on. I would have to press the power button again to turn it on.. I tought the remote battery was just low.

Today when I tried to turn it on nothing is happening and the Red Light is blinking 9 times ??? I tried to unplug it and try it again, still does the same thing ???

We need help...
Lori Nall

Jun 19, 2009 | Sony FD Trinitron WEGA KV-32FS120 32" TV

2 Answers

Sony WEGA Trinitron SRS BBE 32'


Hi,
Please reply couple of questions about TV to guess what could be wrong.

1- How many times standby light blinks, there would be interval of 3 seconds in blinks so count pause to pause.

2- Please intimate exact model of TV, written on sticker pasted at back of TV. That will help me to check its schematics.

Hit " add a comment" button to reply.
Thanks.

May 03, 2009 | Sony FD Trinitron WEGA KV-29LS35 29" TV

3 Answers

Sony WEGA Trinitron SRS BBE 32'


How do you get the green display off of the tv screen?

May 04, 2008 | Sony FD Trinitron WEGA KV-29LS35 29" TV

1 Answer

Turn on problem


Hiii...
I hope you have experience with repir TV because you have common problem whit high voltage on tv board.....
What chassis of you TV set have ?
I hope hear from you soon....

[Vrya]

Feb 17, 2008 | Sony FD Trinitron WEGA KV-27FS100 27" TV

1 Answer

27" Sony Trinitron Wega


Hi

Your TV's memmory IC or Main proccessor ic software get problem. You want to re-programm the ic to over come this problem.

Dec 25, 2007 | Sony FD Trinitron WEGA KV-27FS100 27" TV

1 Answer

Sony Trinitron KV-27V40 27" tv (Dec 1998)


Sounds like you have a short in your set. Probably a shorted horizontal output transistor. You need to have a tech check it out and give you an estimate for repairs. Stargazer

Aug 05, 2007 | Sony FD Trinitron WEGA KV-27FS100 27" TV

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-32FS120 32" TV Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68197 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Are you a Sony Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...