98 Dodge Caravan

Probably is a T-50 bit that fits on your rachet...you can buy a set of star key bits...these are not allen wrenches...Hope this helps.

No has a belt tensioner ( spring loaded ) no adjustment, if weak, will need to be replace.

13mm. hope it helps

I just did my front brakes yesterday and it needed a star drive ( torx wrech ) bit, not an Allen wrench

Not sure what size of 6 cylinder you have so please pick the correct one for your motor size:

1996 Dodge Caravan
3.8 liter V-6 VIN "L"



1996 Dodge Caravan
3.3 liter V-6 VIN "R"




1996 Dodge Caravan
3.0 liter V-6 VIN "3"

You didn't post your engine size so please pick the one that is applicable to you:
1996 Dodge Caravan
2.4 liter DOHC L4 VIN "B"


1996 Dodge Caravan
3.0 liter V-6 VIN "3"




1996 Dodge Caravan
3.3 liter V-6 VIN "R"




1996 Dodge Caravan
3.8 liter V-6 VIN "L"

disconnect brake lines from MC should be only 2. Remove the 2 nuts holding the MC on. replace in reverse order u will need to bench bleed the new MC and u will probaly need to bleed the brakes

6 mm to small 8 mm to big, how about 7 mm would you not think ??

10 MM Wrench or socket. Easy job

You'll need brake line wrenches, this will help you to prevent stripping the heads on the break line screws. Also it depends on whether you are making your own break lines or you are already buying the pieces premade (which I advise doing if you have never flared lines before). Before actually going to get the parts I would take all lines off that need to be replaced, this way you will know exactly how much you will need. This will also help you know the size line and what type of of threading you will need on the ends. I would follow all the lines before taking the tank out, you can sometimes by pass this. Please post more info after you have gotten that far and I'll be sure to follow up. Brake lines and brakes are kind of my speciality.