Question about Bosch Axxis+ WFR 2460 Front Load Washer

2 Answers

WFR 2460 Front loader

Washer overflows from soap dispenser.

Posted by on

  • Anonymous Dec 01, 2008

    same problem - not due to a dirty soap tray. suspect the internal water valve is broken - already replaced cold water valve, now this with the hot water not shutting off.



    Bosch works for a few years - then its a piece of ****.

  • Thomas Landon Jan 28, 2009

    Hi,

    How do you remove the cold water valve. I've gain access and have removed all hoses and electrical, but not sure how to remove valve. I don't want to cause any damage.

    Thanks,
    Thomas

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

We went through the whole "clean the soap dispenser" deal and results were the same. Exploratory surgery revealed that the Prewash hose (for lack of better term), which connects from the top of the drum housing to the right side of the dispenser drawer (facing the machine)was completely clogged with gunk. Especially strange since we don't prewash hardly anything, ever. The hose that connects the bottom of the detergent dispenser with the side of the drum housing did have a lot of buildup, but I do not believe it was the cause because this was only happening on the rinse cycle. I also found the flow meter was frozen up.
WFR 2460 Front loader - c9cc7cfa-6e34-4571-b319-432b94ce532b.jpg

Posted on Apr 12, 2013

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 903 Answers

Take the soap dispenser drawer out and clean the inside where the drawer fits into. Then give the drawer a good clean including underneath it, it could be caused by soap build up.

Posted on Oct 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

There are 3 compartments . . .


It says the 1st compartment going left to right laundry detergant and stain remover, the middle is for the soaking agent, and the last one is for fabric softner. I hope that helps!

You can download the manual online and I found the info on page 12 of the manual.

Mar 02, 2010 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

I have a bosch WFR 2460 washer. Er:15 error code.


You need to check and clean pump filter, normally located behind a removeable plastic cover at bottom front of washer right hand side.
If no filter found there remove rear panel of washer, and clean pump from rear of washer.
Please rate my solution.
Thanks.

Nov 11, 2009 | Bosch Logixx WFT 2806 Front Load...

1 Answer

Door handle is loose and door can't be openBosh washer WFR 2460


Remove the top cover, and release the door catch from inside the front of washer.
Please rate my solution.
Thanks.

Oct 30, 2009 | Bosch Axxis+ WFR 2460 Front Load Washer

2 Answers

Not spinning


Axxis+ WFR 2460 Front Load Washer This washing machine tutorial will show you what to do if the washing machine does not drain or empty the water out this repair was done on a Bosch, Neff and Siemens type appliance.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Dec 28, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

Bosch WFR 2460 washer - Drum does not move during wash/spin cycles


possibly the motor brushes.
take back panel off and motor is held in by bolts which undo - also disconnect electrical plug and socket.
check condition of brushes

Oct 16, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

2 Answers

Bosch WFR 2460 washing machine


the pum should do that but the magnet side may have saturated with water beyond the seal. i recommend replacing the pump.

Mar 16, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

My Axxis wfr 2460 is not releasing the fabric softner from the drawer


You could try a tooth-brush. And after you fill your quantity of softener, top it with water till the exit level of the compartment. You could also check whether water actually pours into the compartment during the final rinsing of the clothes; in this case you should check the inlet pipe screens of your inlet pipe into the machine; which can be done without opening up the machine.

Nov 30, 2007 | Bosch Axxis+ WFR 2460 Front Load Washer

1 Answer

Our Washer is overflowing through the dispenser drawer


water out of the soap drawer could be a multitude of things, start with removing the drawer and checking for blockage in the pipe from the drawer to the drum, next try turning down the water pressure a little sometimes that can help, or has the machine filled up totally till it overflows, that is a blocked pressure switch pipe, start with looking for the blockage first, work with safety unplug if removing lid etc. rate me if i have helped, thank you

Sep 16, 2007 | Maytag Neptune MAH9700 Front Load Washer

1 Answer

Pump blocked message


next time u clean the filter when it is empty of water. put your finger in the whole and u will find somthing wound round the impeler of the pump remove what ever is obstructing and u will have no more problems make sure u unplug the machine b4 you start doing this good luck

Sep 03, 2007 | Bosch Axxis+ WFR 2460 Front Load Washer

Not finding what you are looking for?
Bosch Axxis+ WFR 2460 Front Load Washer Logo

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Tim Whalen

Level 3 Expert

3056 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...