Water has stopped flowing to the ice maker but is ok to the door fountain. hoses appear to be ok.

Sounds like ice maker needs replacing

Change the=> 67006531 Water Inlet Valve I believe the side of your 67006531 Water Inlet Valve that controls water flow to the ice maker has weakened and cannot open properly. Replace the water valves and I believe the ice maker will work fine, Sea Breeze

Either the pipe for the water supply may be bent stopping the flow on your water pressure is too low. below is taken from manual.. The water pressure should be 2.0~12.5 kgf/cm2 or more to run the automatic icemaker. Checkup your tap water pressure ; if a cup of 180cc is full within 10 seconds, the pressure is OK.

The water supply hose that taps into your water supply behind the fridge is very small. It provides water to your ice maker and drinking. The water flow was designed to fill up the ice maker at a specific rate according to the timer wheel, and to reduce splash on the ice maker, which would freeze on the rotating parts and stop your ice maker.

Hi,
Here is a tip that I wrote about the reasons why ice makers do not work.

Ice Maker Problems and Ice Maker Troubleshooting

heatman101


689sshg

Hi,
Here is a tip that I wrote about the reasons why ice makers do not work.

Ice Maker Problems and Ice Maker Troubleshooting

heatman101


sfhgsyw54

OK, that should be no problem. Test your ice maker and fill with water if empty of ice. If full of ice and not moving to dump tell me. I need to help you locate the problem doing that and answering will tell me the problem. Also look around the door frame and inside for the model Profile that you have. and get back with me as soon as possible, Thanks Sea Breeze

I have a maytag side by side with water in the door, the cold water works but the icemaker doesn't. No water flow into the icemaker, it doesn't appear to be iced up. Can not tell if the selenoid works.

sadly you need to turn off the fridge let it dry out with the doors open then turn it back on.

If there is a reset button on your ice maker try pushing it. Many ice makers have two holes for reset. A general rule of thumb is if the ice maker fingers are stopped in a slightly vertical position then your ice maker unit is working. If the fingers are stopped anywhere else then it needs some sort of attention or replaced. Make sure there is water, or ice in the ice maker tray, if not then the problem is with water supply.