I have the same T.V. and it would shut off after a few minutes. I found that the the channel and volume controls on the top right of television were difficult to operate. I had to push down hard to make it work. The controls on the top right of T.V. has a circuit board that falls out of it's cradle which causes it to fall on a metal plate shorting it out.The fix that worked for me: I carefully removed the gray rubber cover from channel and volume control with a pocket screw driver and removed black plastic cradle. I retrieved circuit board,locked it back into it's cradle, reinstalled rubber cover and problem went away. I hope this helps!!!!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I had a similar problem with my Phillips 42 in. LCD HD TV.
Here's the problem. The Power Supply Board. I opened my TV
up(warranty was up of course) and found several bad capacitors.
Phillips and several other companies were sold capacitors that although
were highly rated failed within 5 years because of a lack of
preservatives. All sorts of electronic equipment is now being effected
due to these defective capacitors.
1. Take it in and have it fixed
2. Open it up, check the board for faulty capacitors(bulged or leaking) Buy a new Power supply board and install it.
3. Remove PSB, remove faulty capacitors and replace with compatible new ones.
If it's that new call the place that it was purchased and see about manufacturer warranty... It should have a one-year parts and even that will help...
The problem you're describing is likely the center led or prisim. The unit thinks there is a tape in the tape path and attempting to load it. Not an expensive repair but highly complicated for the average person...
The answer to this depends on the model. My service literature does not reveal the answer, so you will have to call Philips. Try unplugging the TV for a few minutes first. Even if the remote is programmed properly, the lock will still keep it from turning on.
The fact that you have smoke coming from the back is not a good sign if the quality of the picture was good before it failed its worth if you put in 150 to 200.Stay away from it and call a qualified technician for an estimate then you'll know.Good luck.